G-Star RF-2600 User manual

Please read carefully all safety instructions before using this device
2.4GHz RF Stereo Wireless Headset
RF
RF- -2600 2600
Operation Instructions
PC Notebook
A wireless stereo headset with high-quality audio for your PC calling, music, and games. The
advanced 2.4GHz technology allows multiple wireless headsets to operate at the same time
while supporting both audio and voice streaming simultaneously

2
3
4
5
1USB Transmitter (TX):
1. Pairing: Please press the pairing button
with RX pairing button simultaneously
when you first time use this device.
2. LED: Working indicator
Headphone Receiver (RX):
2. Vol+: to increase the volume
3. Vol-: to decrease the volume
4. Power: Long press the power button over
3 sec to activate the device.
5. Pairing: Please press the pairing button
with TX pairing button simultaneously
when you first time use this device.
Rotate to Mute:
The microphone automatically mute when you
rotate it up.
2.4GHz Wireless:
You can move free up to 15m away from your
computer.
Simple Set up:
You can enjoy in seconds with the USB wireless
transmitter without software installation.
10
hr
Convenient Power Battery:
2 changeable AAA batteries and low power
consumption to support the wireless headset.
Built-in headset controls
Instantly access volume controls directly on the headset.
Features
Function Description
2

Getting Start:
TX LED Indicator Status
Solid BlinkSolid Blink
Signal Transmitting
Slow blink
Rapid blink
slow blink
Rx (Red)Tx (Green)
Slow blink
Wireless connected
Rapid blink with beep
Pairing mode
slow blinkPower On
LED Status
Event
1. Insert 2 AAA batteries to headset. Please make sure
the battery directions correct.
2. Connect the USB transmitter on your PC/ laptop,
and press the power button 3 sec on headset to
activate the headset.
3. If it is your first time using this wireless headset,
please operate the pairing process as following:
4. You can start enjoying the wireless headset now!!
a. Simultaneously press the pairing key on TX\RX
as rapid LED blink.
b. The LED will be slow blink while the pairing
succeeded.
1
2
Set up:
Control:
Rotate to Mute:
The microphone automatically mute when you rotate it up.
Note:
• You can directly use the headset without pairing after the first pairing operation.
• 10-minute auto-off when wireless adapter not detected
Notice: The headset has a wireless range of up to 15m. However, wireless performance
may be affected by walls, metal items, and other wireless devices (e.g. WLAN…etc).
When the headset is moved to the limit of wireless range, audio may become distorted
and eventually cut out. Moving closer to the wireless adapter will restore clear audio.

Specifications
RF Specifications
1. Receive Frequency Range: 2.4GHz~2.4835GHz Unlicensed ISM Band.
2. Spread Spectrum: Frequency Hopping Spread Spectrum (FHSS)
3. Radiated Output Power: 0-4dB.
4. Modulation method: GFSK
5. Transmission Range: Up to 15M.
Speaker Spec:
1. Driver Unit: 40mm.
2. Frequency Response: 20Hz~20kHz.
3. Impedance: 32 Ω.
4. Sensitivity: 115 ±4dB.
5. Max. input: 100mW.
6. Total Harmonic Distortion (T.H.D): Less than 2%.
Microphone Spec:
1. Directivity: Omni.
2. Impedance: 2.2kΩ.
3. Frequency: 100~10KHz.
4. Sensitivity: -54 ±3dB.
Safety Notice