Gainward Hollywood@Home TV2GO User manual
Hollywood@Home
TV2GO
Quick Start
Copyrights and Liabilities
The information contained in this manual has been validated at the time of publication. The
manufacturer reserves the right to make any changes and improvements to the products
described in this manual at any time and without prior notice. Consequently, the
manufacturer assumes no liability for damages incurred directly or indirectly from errors,
omissions or discrepancies between the product and the manual.
All registered trademarks are the property of their respective owners.
Copyright © 2004 All rights reserved. No reproduction of this document in any form is
permitted without the prior written authorization from the manufacturer.
Trademark
All products and company names are trademarks or registered trademarks of their respective
holders.
Contents
-TV2GO
-TV2GO Software and DriverCD
-TV2GOQuick Start Manual
-Remote Control with Batteries
-USB B-to- B Cable
-Audio Input Cable
-Audio Output Cable
-S-Video Cable
-Composite Video Cable
-SVHS to RCA Cable
Page 1 Page 2 Page 3
Installation Step 1: Turn on the PC
Power on the PC and wait until Windows is running
Installation Step 2: Install Driver
1. Plug in the TV2GO into the USB slot
2. Windows should automatically ask for driver
3. Put the CD-ROM into the cd-rom drive
4. Direct the installation program to look for driver in the
“EMPIA0910 For LG” directory in the CD-ROM
Installation Step 3: Install the TVR Program
1. You need to install the drivers manually. Insert your
driver CD disk into CD-ROM and run it.
2. Please choose setup language then click on “Next”
and follow the instructions on the screen.
3. To finish the installation select “Finish”, then enter
the CD key. Later you will also find an icon on desk-
top area to launch the TV2GO.
Installation Step 4: Install Driver
Audio output to PC audio line in
Audio input
S-Video or
Composite Video input
TV Co-Axle input
Remote control sensor
Version 1.00 02/2004
Page 4 Page 5 Page 6
Installation Step 5: Connect the Video input Remote Control Trouble Shooting
PC Audio
Line In Cable
Co-axle Cable
Connect Co-axle source
Connect Composite source
Composite
Cable
Composite
Connection
Cable
Connect S-Video source
S-Video Cable
Channel Surfing:
Display TV channels in thumbnail
mode
Source:
Switch between TV Air/TV Ca-
ble/S-Video/Composite Video
Mute:
Mute Sound
Power:
Turn the TV Plus program on or off
Channel
Switch TV channel
Volume
Increase or decrease sound volume
REC:
Start video recording
Time Shift
Turn on Time Shift
Full Screen
Change video window into full
Audio Input cable
● TV2GO will only support Windows XP and Win-
dows 2000. It will not run under Windows 98, Win-
dows 95 or Windows ME.
● TV2GO has two types of USB connector: USB
adapter and USB cable. Please use USB cable if
there is interference problem with USB adapter.
● TV2GO remote control sensor is located on top of
the unit. Please aim the remote control at that loca-
tion for best result.
TV Plus program
System Requirement
PC or Notebook with
● Intel or compatible processor
● minimum of 64 MB RAM
● CD-ROM
● one free USB 2.0 port ***
● sound card with Line-in input connector
● MS Windows 2000, MS Windows XP, MS Windows
MCE
*** Note: This product will also work on PC systems with USB 1.1,
however at low video quality and video frame rate
USB B to B Cable
PC Audio
Line In Cable
PC Audio
Line In Cable
Audio Input cable
USB B to B Cable
USB B to B Cable
Please refer to the TV_Plus directory in the CD-ROM for TV
Plus user manual.
