GAMING SUPPORT SHOT CLOCK User manual

Quick Start Guide
V 1.3
Gaming Support BV
Industrieweg 29
3044 AS Rotterdam
The Netherlands
[phone]
Micro USB
Socket
Decimal
Dot
© 2023 Gaming Support All Rights Reserved© 2023 Gaming Support All Rights Reserved
5
gamingsupport.com
If the decimal dots in
the display are visible
or the unit will not
start, the battery is
running low.
Charge the clock
before continuing.
Plug the charger into
the micro-USB port
on the bottom side of
the Shot Clock
The yellow LED will
show charging is in
progress.
When fully charged
the green LED on the
top will illuminate.
• Only use the battery charger as supplied
Charging the battery
V 1.3 - Quick Start Guide
Power
Charge
OffStandby

V 1.3 - Quick Start Guide V 1.3 - Quick Start Guide V 1.3 - Quick Start Guide
© 2023 Gaming Support All Rights Reserved © 2023 Gaming Support All Rights Reserved© 2023 Gaming Support All Rights Reserved
234
Gaming Supports
Shot Clock is a physical
clock on the poker table
that counts down the time
players have left to act
on their hand.
Once the clock reaches
zero without the player
having decided to call,
fold, bet, or raise, a play-
er’s hand is either dead,
or a player is forced to
buy more time from the
bank.
TOP BOTTOM
Power
Charge
OffStandby
Power switch
Micro USB Socket
Button 2
(Green)
Button 1
(Blue)
LED Indicator
(Yellow)
LED Indicator
(Green )
Introduction
1. Before using the Shot
Clock, ensure that the
battery is charged.
2. Slide the switch on
the bottom from “off” to
“standby”.
3. Press and hold the blue
button for 2 seconds.
4. A beep will sound and
the numbers on the
displays will light up.
5. The Shot Clock is now
ready for use.
Getting ready
Operation
1. Press green button to start
countdown. Press again to pauze
and repeat to continue.
2. Hold green button to
reset to start value.
Make sure countdown has stopped.
Hold green button for 6 seconds to switch
clock to standby mode. If the Shot Clock
is not used for 10 minutes it will automat-
ically switch to standby mode.
Press blue button after start to
add time to countdown when
player buys extra time
Default time
• Hold blue button
for 3 seconds to set
default time.
• Press green to in-
crease (+).
• Press blue to de-
crease (-).
• Hold blue button for
3 seconds to save
settings.
Display intensity
• Hold green button
for 3 seconds to set
display intensity.
• Press green to in-
crease (+).
• Press blue to de-
crease (-).
• Hold green button
for 3 seconds to save
settings.
Settings