G&G Paw Brothers PBP89430C User manual

Paw Brothers®
Professional Hybrid Cages
PBP89430C & PBP89435C
Assembly Instructions
Copyright © 2013, G & G Distribution, Inc. All Rights Reserved

2
Initial Inspection
When your Paw Brothers® Professional Hybrid Cage arrives, check immediately for signs of
shipping damage. If you notice damage, save the shipping carton for claim purposes, and im-
mediately report the problem to your supplier and to the shipping company.
Caution: Use safety gloves when handling all parts. Some edges may be shar p.
Read all instructions.
Tools required for assembly: # 2 Phillips Screwdriver and 2 hex head wrenches
(included)
Parts List:
1 Door Assembly PBP89485 PBP89486
2 Top/Bottom Panels PBP89485-1 PBP89486-1
2Side Panels PBP89485-2 PBP89486-2
1Back Panel PBP89485-3 PBP89486-3
2Hex Head Wrenches PBP89478-1
1Bag of Self-tapping Sheet Metal Screws PBP89478-2
8Hex Head Fasteners PBP89478-3
1Floor Grate PBP89465 PBP89466
1ABS Plastic Pan PBP89450 PBP89454

3
Assembly Instructions:
Step 1. Unpack all cage parts and compare all the pieces to the parts list.
Step 2. Using a #2 Phillips screwdriver, put two side panels and top/bottom panel together with sheet
metal screws. The flanges face out as shown in Figure A below.
Step 3. Assemble the remaining top/bottom panel to the other panels with sheet metal screws as
shown in Figure B.
Step 4. Put the assembled panels face down with the front of the cage on the ground. Assemble the
back panel to the other four panels with sheet metal screws. (See Figure C)
NOTE! For proper panel alignment, do not completely tighten the screws until each hole
has a screw.

4
Step 6. Assemble the Door Assembly to the cage using the Hex Head Fasteners as shown in Figure E.
Hex Head Fastener installation
Figure G
Step 7. Place the Floor Grate in the cage. Slide the ABS Plastic Pan underneath the grate. See Figure G.