Ganz ZN-YH305 User manual

Warning Before Installation
Contact your distributor when such
cases happen.
Power off the IP Camera as
soon as it is found smoking or
smelt unusual.
Do not place the IP Camera
around the heat sources, such
as television or oven.
Keep the IP Camera away
from direct sunlight.
Keep the IP Camera away
from water. If the IP
Camera is wet, power off
immediately.
Refer to your user's
manual for the operating
temperature.
Do not place the IP Camera
in high humid environments.
Contact your distributor when such
cases happen.
1

2
Do not place the IP Camera on
unsteady surfaces.
Do not disassemble the IP
Camera.
Do not insert any object
into the IP Camera, such as
needles.
Do not touch the IP Camera
when it's lightening.
Do not drop the IP Camera.

Camera stand
ZN-YH305
Quick installation guide Warranty card
Power adapter
Software CD
Check Package Contents
1
3

4
Front panel
Manual focus ring
MIC
Internal ring screw
MIC In
Power cord socket
Audio out
General I/O
terminal block
Indented
reset button
Ethernet 10/100
RJ45 socket
Back panel
Up cover
Status LED
Physical Description
2

Install your IP Camera in Ethernet network
1. If you have external
devices such as sensors
and alarms, make
connection from general
I/O terminal block.
3. Finally, connect power
cord to a power outlet.
2. Use Ethernet cable to make
connection from Ethernet 10/100
RJ45 socket to the hub.
＊Use Category 5 Cross Cable when
IP Camera is directly connected to
PC.
5
Make Connections
3

6
001CB83
RoHS
Pat. 6,930,709
IP Camera
Model No:ZN-YH305-A
Note the serial number from the label on the unit.
This serial number is same as Ethernet address,
for example: 001CB8300052=00-1C-B8-30-00-52
001CB83
RoHS
Pat. 6,930,709
IP Camera
Model No:ZN-YH305-A
A
Assign IP Address
4

7
Assign IP address
B
Using Installer program
1. Run the "Installation Wizard" under the Software Utility directory from software CD.
2. The program will search the GANZ Video receivers, Video servers or IP cameras
on the same LAN.
00-1C-B8-30-00-52
00-1C-B8-30-00-52
3.After searching, the main installer
window will pop up. Click on serial
number that matches the one you
just noted from previous page.
4.Click "Link to selected device(s)" to
connect the Internet Explorer to the
IP Camera.
For further setup, please check the user's manual on the software CD.
The Internet Explorer Connects to the IP Camera
5