ASSEMBLING AND USING YOUR PRODUCT
Unpack all components carefully.
Set up the steel frame in the desired place on an even, solid surface. Please keep in
mind that some water may splash over the rim of a bowl, do not set up the cascade
fountain on a surface which may be damaged by water.
Connect the hose from the top jug to the vent of the pump and place the pump on the
floor of the reservoir bowl. Place all remaining bowls onto the frame.
Fill reservoir with clean water and ensure pump is fully submerged.
Connect the pump cable to the socket of the control housing on the rear side of the
solar panel; the solar fountain is now ready to use.
OPERATING INSTRUCTIONS
Turn on the pump: short press the ON/OFF position to turn on the pump, the pump will run
certain hours (refer to battery status) and turn to solar mode automatically. The pump will
operate automatically next day in direct sunlight.
Charge the battery: press and hold on 3 seconds to turn OFF the pump and charge the full
solar energy to battery during day time, turn on the pump when you need it (on demand).
Battery status:
Green: battery is full charged. Pump will run around 6-8 hours.
Orange: battery is half charged. Pump will run around 2-6 hours.
Red: battery needs charges. Pump will run less than 1 hour.
(Note: In order to protect battery, don’t manually turn on the pump frequently)
Note: The indicator light is solid when charging battery.
PUMP PERFORMANCE IN DIFFERENT WEATHER CONDITION:
Weather 1. Pump on
2. Charge extra solar energy to
battery
1. Pump off
2. Charge full solar energy to
battery
Solar runs the pump and charges
the battery. Pump performance is
maintained when the clouds pass.
Pump runs on fully half an hour longer
into the evening.
Battery should be fully charged in 1
day.
Solar runs the pump and supplies extra
energy to the battery. Performance
is maintained when the clouds pass.
Pump will only run a shorter period of
time into the evening.
Battery will take 2 to 3 days to fully
charge.
Pump will only run when there is
sufficient power from the battery. Little
or no battery charging occurs so pump
performance is not maintained.
Battery will take several days to fully
charge.
No solar power is available, pump will
not run and battery will not charge.
Battery will not charge.
If the pump stops running when cloudy or night, and you want to force the pump running for
certain hours, short press to turn on the pump, the pump will run hours until battery flat.
CLEANING & MAINTENANCE
Pump: lf, after a period of time, the pump starts to lose power or stops working check for
the build up of sediment, scale or dirt in the filter. Remove the pump cover and the impeller
cover. Clean them and the filter by fresh water.
Solar panel: The panel should be cleaned periodically with a soft tissue. Regular
cleaning of the panel is advised to maintain optimum conversion of the sun’s energy
into direct current.
SWGSL227 Manual AW - A4 Folded.indd 2 19/02/2019 10:55
