Garfield International PARAGON 103 User manual

SAFETY INSTRUCTIONS
Please read the safety precautions before using this
product. Safety precautions help you properly use this
product and prevent you from injuring yourself and/or
others.
GENERAL PRECAUTIONS
1.This appliance is not a toy. Keep away from children
and infants.
2.Do not use this unit for purposes other than its
intended purpose.
3.When not in use, always unplug the unit and store in
a cool dry place.
4.The water jar can be extremely hot during and
immediately following use. Do not attempt to remove,
handle, or insert the water jar when hot, during
operation, or immediately after use.
CAUTION: TO REDUCE THE RISK OF ELECTRICAL
SHOCK, DO NOT OPEN COVERS. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
1.Do not attempt to cut or modify the power supply
cord.
2.Do not pull/handle the power supply with
unnecessary force.
3.Discontinue use immediately if the cord is damaged
or becomes hot.
4.Do not wrap the power supply cord around the unit
during use.
5.Do not use the unit near flammable material
including but not limited to benzene, paint thinner,
aerosols, and etc.
6.Do not place or store product near exposed water
such as bathtubs, sinks, and etc.
7.Do not handle electrical appliances or products with
wet hands.
DAILY MAINTENANCE
Unit should be cleaned and inspected on a daily basis or
once before each day’s use.
1.Check to see that the unit is in good working
condition and that there are no exposed parts or
wires.
2.Check that the unit is resting firmly on a stable
surface away from open sources of flame and/or
water.
3.Check for broken parts, jars, etc.
www.garfieldint.com
Questions or Comments?
Please call 1-888-731-6688
GARFIELD INTERNATIONAL CO., INC.
PARAGON®is a trademark of Garfield International.
Before installing and using this unit, please carefully
read these instructions. Be sure to keep this
available for later reference.
PARAGON®
103 FACIAL STEAMER




PARTS IDENTIFICATION
(1) Aroma Insert Space
(2) Steam Outlet
(3) Steam Arm
(4) Plastic Lid
(5) Water Cup
(6) Max Water Level Line
(7) Min Water Level Line
(8) Burn Guard
(9) Steam ON/OFF
(10) Sanitation ON/OFF
(11) Auto-Off Tipping Switch
ASSEMBLY
1. Install the steam arm by gently pushing it into
the dome portion of the unit.
2. Install the water cup. Gently turn the water cup
in a counter-clockwise direction until it locks in
place.
When properly installed, the water cup handle
should be centered between the burn guards.
3. Push the burn guards into place.
4. Place the facial steamer onto a stable and flat
surface.
5. Open the plastic lid and remove the water plug.
6. Pour distilled water into the water cup to the
maximum water level line. To prevent water from
spouting do not to exceed the top red line.
7. Connect the plug to the power source
8. Push the steam power switch to its ON position.
The green activate lamp will light up.
9. Wait 7-10 minutes for steam to appear. Wait
until the steam is a steady fine mist before
directing the steam towards the client.
AROMA THERAPY
Using the aroma therapy strips, place a few drops of
aroma onto the strip. Do not soak the strip. Place the
aroma strip into the Aroma Insert Space and slide the
cover to close. This design allows the client to
experience the benefits of aromatic oils while
simultaneously protecting the appliance from clogging
and spouting.
OZONE
Ozone is a form of oxygen sometimes used as a form of
disinfectant. The ozone function in the facial steamer is
an option. Check with applicable regulatory agencies
such as the Department of Health and the Cosmetology
State Board concerning the use of ozone in your area.
To activate the ozone function, use the on/off switch
located next to the timer knob. When ozone is in use, the
green activate lamp will light up.
AUTO-OFF TIPPING SWITCH
This unit must be operated on a flat, hard, and stable
surface. DO NOT SET UNIT ON A SOFT SURFACE.
The auto-off tipping switch must be engaged for proper
operation. In the event that this vaporizer is tipped over
the auto-off tipping switch will release and shut the unit
down as a safety precaution.
120V , 400W , 3.33amps
For your protection in the event of theft or loss of this
product, please fill in the information below for you own
personal records.
Serial No. : _____________________
Date of Purchase: _____________________
Purchased From: _____________________
www.garfieldint.com
Questions or Comments?
Please call 1-888-731-6688
GARFIELD INTERNATIONAL CO., INC.
PARAGON®is a trademark of Garfield International.
W A R N I N G
USE ONLY DISTILLED WATER WITH THIS
MACHINE. DISTILLED WATER SHOULD
BE USED TO HELP PROLONG THE LIFE
OF THE MACHINE. DO NOT RUN
CHEMICALS THROUGH THE APPLIANCE
SUCH AS CLEANING AGENTS OR
AROMA ADDITIVES. THESE CLOG THE
WATER WAYS AND LEAVE DEPOSITS.
TO AVOID STEAMER BURNOUT DO NOT
TEST RUN THE APPLIANCE DRY
TO PREVENT WATER FROM SPOUTING -
ALWAYS MAINTAIN THE DISTILLED
WATER LEVEL AT THE PROPER LEVEL
BETWEEN THE TOP AND BOTTOM RED
LINES.
TO EXTEND THE LIFECYCLE OF THE
HEATING ELEMENT AND TO PREVENT
THE WATER JAR FROM CRACKING, DO
NOT ADD COLD WATER WHILE WATER
IS HOT. WAIT FOR UNIT TO COOL
BEFORE ADDING MORE WATER.


