Getting Started
WARNING
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Installing the Memory Card
The camera requires a microSD™ or microSDHC memory card
of up to 64GB with a speed rating of class 10 or higher. You can
use the included memory card, or you can purchase a
compatible replacement memory card from an electronics
supplier.
1Insert the memory card À into the slot Á.
2Press it in until it clicks.
Removing the Memory Card
NOTICE
Removing the memory card while the device is turned on can
result in a loss of data or damage to the device.
1Turn off the device.
2Press the card in until it clicks.
3Release the card.
The card ejects from the slot.
Device Overview
ÀPress to turn the device on.
Hold for 3 seconds to turn the device off.
Select to return to the previous page.
ÁSelect to scroll through menus or pages.
ÂSelect to scroll through menus or pages.
ÃFrom the viewfinder, select to save a photo.
Hold to save a video clip.
Select to choose an option in a menu.
Installing the Mount onto Your Windshield
NOTICE
The adhesive mount is extremely difficult to remove after it is
installed. You should carefully consider the mounting location
before you install the mount.
Before you can install the adhesive mount onto your windshield,
the ambient temperature must be from 21° to 38°C (from 70° to
100°F).
TIP: You can connect the device to power and hold the device in
the preferred mounting location to check the camera's field of
view at that location.
1Clean the windshield using water or alcohol, and a lint-free
cloth.
The windshield must be free of dust, wax, oils, or coatings.
2Remove the protective film from the mount adhesive.
3Position the mount over the mounting location.
TIP: The adhesive is extremely sticky. Do not touch the
adhesive to the windshield until the mount is properly
positioned and aligned.
4Press the mount firmly onto the windshield, and maintain
pressure for 30 seconds.
5Pull the camera and mount away from the windshield.
The metal disk remains attached to the windshield.
6Using your finger, press firmly on the disk for 30 seconds.
This helps to ensure the disc adhesive has proper contact
with the windshield.
7Wait 24 hours before installing the Dash Cam.
It takes 24 hours for the adhesive to bond properly to the
windshield.
Installing and Setting Up the Dash Cam
NOTICE
Before installing the Dash Cam, you must install the mount and
allow the adhesive to bond to the windshield for 24 hours.
Failure to allow adequate bonding time may cause the mount to
detach from the windshield, which could result in damage to the
product or mount.
1Place the camera and mount onto the magnetic disc.
2Plug the vehicle power cable into the USB port on the device.
Getting Started 1
