Installing the Antenna on the
Group Ride Radio Mount
NOTE: The mounted antenna must be at
least 4 cm (1.57 in.) away from the
nearest roll bar or metal surface to avoid
radio interference.
You can mount the antenna directly onto
the Group Ride Radio mount. For the best
results, use this method only in vehicles
that do not have a roll cage.
Screw down and tighten the antenna
onto the Group Ride Radio mount.
Relocating the Antenna
NOTE: The mounted antenna must be at
least 4 cm (1.57 in.) away from the
nearest roll bar or metal surface to avoid
radio interference.
You can use the antenna relocation kit to
mount your antenna in a more suitable
location for your vehicle, such as a roll bar
at the rear of your vehicle, to receive
better radio reception. For the best results,
use this method for vehicles that have a
roll cage.
1Screw down and tighten the antenna
cable onto the Group Ride Radio
mount .
2Find a suitable location for the
antenna.
3Using a flat head screwdriver or 5/16
in. (8 mm) nut driver, loosen the bolt
on the antenna relocation mount
until the ring separates.
4Place the mount around the roll bar.
5Tighten the bolt on the mount until the
ring is secure.
6Screw down and tighten the antenna
onto the antenna relocation plate.
7Route the antenna cable along a
suitable path in your vehicle, and
secure it using the included zip ties.
2 Quick Start Manual