Garmin GHS II User manual

0
-
,,,
April 2010
190-00835-03 Rev. A
Printed in Taiwan

GARMIN.
Instructions 2
Instructions 4
lstruzioni 7
Anweisungen
10
Instrucciones
13

GHS™ 11
Instructions
Important Safety Information
&WARNING
See the Important Safety and Product
Information guide in the product box for
product warnings and other important
information.
.&. CAUTION
Always wear safety goggles, ear
protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
Mounting Considerations
NOTICE
This device should be mounted in a
location that is not exposed to extreme
temperatures or conditions. The
temperature range for this device is listed
in the product specifications. Extended
exposure to temperatures exceeding the
_ specified temperature range, in storage or
operating conditions, may cause device
failure. Extreme-temperature-induced
damage and related consequences are
not covered by the warranty.
When drilling or cutting, always check
what is on the opposite side of the surface.
When selecting a mounting location,
observe these considerations.
• To avoid interference with a magnetic
compass, do not install the device
closer to a compass than the
compass-safe distance value listed in
the product specifications.
Tools Needed
• Pencil
• Drill
• 22 mm (7/
8
in.) drill bit or hole saw
• 3 mm (1/8 in.) drill bit
• 4.76 mm (3/
16
in.) wrench
• Phillips screwdriver
• Marine sealant { optional)
2
• A 10 m (32 ft) extension cable is
included to connect the handset to the
VHF radio. You must select a
mounting location for the handset that
allows this extension cable to connect
to the back of the VHF radio.
• You can use the included screws to
mount the extension cable and the
Instructions

handset cradle mount on your boat. If
the included screws are not
appropriate for the mounting surface,
you must purchase suitable hardware.
Installing the Extension Cable in the
Mounting Surface
Before drilling a hole to mount the
extension cable, you must make sure that
the extension cable is long enough
connect to the back of the VHF radio from
the selected mounting location .
1 Using the mounting plate G) as a
template , trace the cable hole in the
center of the mounting plate and mark
the screw locations.
2 Set the mounting plate aside.
Do not drill through the mounting plate .
3 Using a 22 mm (7/
8
in .) drill bit or hole
saw , drill the center cable hole CV in
the mounting surface.
4 Using a3 mm (1/
8
in .) drill bit, drill the
pilot holes .
5 Apply marine sealant between the
mounting plate and the mounting
surface to help seal the holes
( optional) . '
6 Using the included screws , attach the
mounting plate to the mounting
surface.
7 Connect one end of the extension
cable to the microphone relocation port
on the back of the VHF radio , and
route the other end of the extension
cable to the mounting location.
8 Feed the extension cable connector ®
through the back of the mounting
surface.
9 Apply marine sealant around the
extension cable connector in the
mounting plate to help seal the hole
(optional).
1O Secure the extension cable connector
to the mounting plate using the
weather cap @ and the nut @.
- ----- - ------ - --·-- - -- --- ------ - ---
Instructions 3

11 Connect the handset to the extension
cable .
Installing the Cradle Mount
1 Select a mounting location near the
extension cable.
TIP: You can place the handset in the
cradle mount, connect the handset to
the extension cable, and hold it against
the mounting surface to help
determine the best location.
2 Using the cradle mount as a template ,
mark the screw locations .
3 Set the cradle mount aside.
Do not drill through the cradle mount.
4 Using a3 mm (1/
8
in.) dr i ll bit, drill the
pilot holes.
5 Using the included screws , secure the
cradle mount to the mounting surface .
Specifications
Specification Measurement
Dimensions
(HxWxD)
Weight
154 x 69 x 40 mm (6 .1x
2.7 X 1.6 in.)
318 g (11.22 oz.)
Specification
Measurement
Temperature Operating: From -15° to
range 70 °C (from 5° to 158 ° F)
Storage: From -20 ° to
70 °C (from -4 ° to 158 ° F)
Compass-safe 60 cm (23.6 in .)
distance
Water rating IEC 60529 IPX?*
*The device withstands incidental
exposure to water of up to 1m for up to
30 min. For more information, go to
www.garmin.com/waterrating .
·- ------ -------------- --------------
4
Instru c tions

support.garmin.com
© 2017 Garmin Ltd. or its subsidiaries
Garmin' and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other
countries. GHS"' is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the
express permission of Garmin.
~ lR[ C€
Printed in China Ii•:;~
July2017
190-02061-96_0A