Garvin Adventure Roof Rack Ladder User manual

Garvin Adventure Roof Rack Ladder
Installation Guide for Jeep Wrangler '07-'16 2-Door JK
Installation Time: <1 Hour
Tools Required:
Box Cutter/Knife
Pliers
13mm Socket
Socket Wrench
Installation Instructions:
Note: This product requires a pre-existing Garvin Adventure Roof Rack. This product will not work without it.
1. Carefully open the package using a box cutter or knife (Figure A) and pliers. Ensure the ladder and hardware are
included and undamaged (Figure B).
Figure A

Figure B
2. Locate the ladder support brackets on the rear passenger portion of the Garvin Adventure Roof Rack (Figure C).
Figure C
3. Insert two carriage bolts (supplied) through the top portion of the ladder (Figure D).

Figure D
4. Insert the connecting bracket (supplied) to the support bracket closest to the front of the vehicle using a
carriage bolt (supplied) and insert the carriage bolts from the top of the ladder into the connecting bracket
(front facing) and support bracket (rear facing) (Figure E).
Figure E

5. Place a flat-washer and nylon locknut (supplied) on the underside of all three carriage bolts and hand-tighten
(Figure F).
Figure F
6. Insert two carriage bolts through the lower ladder support bracket and the support bracket on the rear
passenger side support bar of the roof rack and hand-tighten (Figure G).
Figure G
7. Tighten down all the locknuts using a 13mm socket wrench (Figure H).

Figure H

Before
After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 10/24/2017