Denali MA11145 User manual

866.527.7637 1 [e-mail]
DENALI Plow Mount
MA11145
CanAm Outlander
Thank you for purchasing our DENALI plow mount. You now own a premium custom
plow mount to allow you to use your plow with your ATV. Please note the following
instructions and heed all warnings.
•Your ATV and/or plow system can cause death or injury, please use caution and
common sense when operating your unit.
•Read your Plow Operator Manual, your Winch Operator Manual, and all warning
labels before operating your ATV.
•Operate your ATV at a walking speed with the blade installed. Do not exceed 5
mph (8 km/h), even with the blade up.
•Do not operate the ATV on slopes greater than 10 degrees with the plow
installed.
•Always lower the plow to the down position before leaving your ATV unattended.
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

CanAm Outlander
MA11145 22000 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 2 [e-mail]
Please verify that all hardware and parts are included in your package.
Kit Contents:
Item Number
Description
Quantity
1
MA11145 Mounting Plate
1
2
½-13x1.5” Hex Bolt
4
3
½” Washer
3
4
MA11145-4 (Bigger Bracket)
1
5
MA11145-3 (Smaller Bracket)
1
6
½” Lock Washer
4

CanAm Outlander
MA11145 22000 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 3 [e-mail]
Plow Mount Assembly:
1. Locate notch on the plastic skid plate. See Figure 1.
FIGURE 1
2. Locate the hole on the metal skid plate to the right and left of the notch
3. Mark where the holes are and drill out a half inch hole. See Figure 2.
FIGURE 2

CanAm Outlander
MA11145 22000 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 4 [e-mail]
4. Locate the bolt indent on the plastic skid plate. See Figure 1.
5. Locate the hole on the metal skid plate to the right and left of the bolt indent.
6. Mark where the holes are and drill out a half inch hole. See Figure 3.
FIGURE 3
7. Place the smaller bracket, MA11145-3, above the holes drilled next to the bolt
indent.
8. Place the bigger bracket, MA1145-4, above the holes drilled next to the notch.

CanAm Outlander
MA11145 22000 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 5 [e-mail]
9. Raise plow mount up to the plastic skid plate and insert and all for ½” bolts with
washer and lock washer then tighten the bolts. See Figure 4.
FIGURE 4
Plow Installation:
1. Slide the plow into position with the tubes under the ATV. Lift the end of the tube
assembly into position so the holes in the tube wings line up with the 3/8” holes in
the frame brackets.
2. A Phillips head screwdriver may be used to align the holes. Insert both 3/8” pins and
hook the retaining clips on the ends of the pins to secure the plow to the ATV.
3. The plate should now be a permanent part of your ATV and will not interfere with
clearance. The plow can be easily attached and detached on the welded U-bolt with
the clevis hook on a winch or a manual lift assembly.