Gator Kennels Kennel Gate User manual

Angled
Aluminum
Hinge
Bars
Gate installation
Parts Needed:
1. Attach wall-brackets to existing walls with appropriate anchors for your wall-type.
• Be sure the paw-prints are at the TOP
2. Attach hinge-bars to the angles.
• One paw-print will be at the top - the other will be at the bottom.
(depending on which side of the angle you chose to have the hinge on)
• Use ¼-20x¾”pan-head screws, lockwasher, and washer to bolt hinge-bars to angle.
There will be two holes at the bottom and two holes at the top of the angle that will not be used - yet.
Wall Wall
¼“ Lock
Washer
¼“ Flat
Washer
¼-20 x ¾”
Pan-head screw
Paw-prints
Page 1 of 4
Gator Kennels Gate-only assembly instructions

GateLatch
Gate installation
Parts Needed:
3. Drop Gate onto hinge-bar you want to act as the hinge.
• The gate will be short of reaching the other hinge-bar.
4. Attach latch to other side of gate.
• Use ¼-20 x 1”screw and nylockto attach the latch.
• The latch should now reach the other hinge-bar.
• Adjustments to the hinge-bar may be needed for smooth operation.
Wall
Wall
“ Nylock
Nut
-20 x1”
Pan-head
Page 2 of 4
Gator Kennels Gate-only assembly instructions

6. Attach gate safety screw.
• In the event a dog can figure out to push up the gate far enough to spring it from its hinges, we've
included a small screw and nut that keeps that from happening.
• There should be a small hole in one of the hingepins.
• Insert the screw into the hole and tighten the nut.
• You can test the safety by trying to lift the entire gate. The screw should stop the gate from lifting.
5. Attach the latch-lock to the top of the gate
• Use ¼-20 x 1”Pan-head screws and nylocks to attach the latch-lock.
• Be sure the plastic piece is pointed toward the latch.
Gate installation
Parts Needed:
¼“ Nylock
Nut
¼-20 x 1”
Pan-head
Latch
Lock
Safety Screws Safety nuts
Page 3 of 4
Gator Kennels Gate-only assembly instructions

Gate installation
Parts Needed:
7. Attach the header above the gate.
• Use ¼-20 x ¾”Pan-head screws, lockwashers, and flat washers.
Wall
Wall
¼“ Lock
Washer
¼“ Flat
Washer
¼-20 x ¾”
Pan-head screw
Header
Enjoy your new kennel gates!
Page 4 of 4
Gator Kennels Gate-only assembly instructions