GE Monogram Pro ZDP304LP User manual

GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
Models affected:
F - 9 fault code on Monogram Pro Range
ZDP484LGP
ZDP484NGP
ZDP486LDP
ZDP486LRP
ZDP486NDP
ZDP486NRP
ZDP304LP
ZDP304NP
ZDP364LDP
ZDP364LRP
ZDP364NDP
ZDP364NRP
ZDP366LP
ZDP366NP

GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
F - 9 fault code, causes and repair
F -9 codes are set when the control board does not see sail switch circuit close.
Check the cooling fan operation. If oven temperature is over 200°F the motor should be running.
•The cooling fan motor windings can be checked at relay board J5-pin 2 OW wire to W neutral wire.
•Resistance is 20Ω. ± 10%
•If cooling fan is operating, verify sail switch is closed. Check at:
•Relay board J17-pin 1 P to J16-pin 5 W.
•If switch circuit is open, access the cooling fan assembly.*
•Check switch and replace if needed. If switch is good,
•Proceed with following:
Shown with fan running
There is a small amount of tolerance for the sail movement. If the range is installed against the wall, the range’s
back cover can be pushed in, this condition causes the sail to touch the range back and not activate the switch.
See next page.
* Refer to service guide 31- 9181 for disassembly instructions
1

GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
Restricted Sail Switch operation
Back Cover limiting sail movement
To correct this condition a shoulder screw will be installed on the cooling fan bracket to maintain the critical
spacing between the back cover and the sail of the sail switch.
Cooling Fan
OFF
2

GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
Insert
shoulder
screw here.
WB01X21893 –Shoulder
screw
3

GE Appliances & Lighting
General Electric Company
Louisville, KY 40225
GEAppliances.com
ZDP304LP
ZDP304NP
ZDP364LDP
ZDP364LRP
ZDP364NDP
ZDP364NRP
ZDP366LP
ZDP366NP
ZDP484LGP*
ZDP484NGP*
ZDP486LDP*
ZDP486LRP*
ZDP486NDP*
ZDP486NRP*
*On double ovens install both screws
Only need access
to screw holes on
cooling fan
brackets
4