Specification Created 6/02
GE Appliances
GSD5700G – GE Built-In Dishwasher
For answers to your Monogram,
® GE Profile™or
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center®service, 800.626.2000.
Built-In Dishwasher Dimensions
(in inches) Wood Insert Cut-Out Dimensions
(flat door models only)
Electrical Rating
Voltage AC . . . . . . . . . . . . . . . . . . . . . . . 120
Hertz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
Total connected load amperage . . . . . . . 8.2
Calrod®heater watts max. . . . . . . . . . . . 725
For use on adequately wired 120-volt,
15-amp circuit having 2-wire service with
a separate ground wire. This appliance
must be grounded for safe operation.
As an ENERGY STAR®partner,
GE has determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency.
Dishwasher Rough-In Information
Note: Dishwasher must not be installed more than 10 feet
from sink for proper drainage. All plumbing and electrical
work must be in accordance with local codes.
Note: If a flush look is needed, a 25" base cabinet needs
to be used.
The power cord and connections must comply with the
National Electrical Code Section 422 and/or local codes and
ordinances. The cord must be no longer than 6 ft. from the
junction box to the receptacle.
Installation Information
(in inches)
D – Panel
Kit A B C Thickness
GPF425 19-3/4" 23-9/16" 3-11/16" 1/4"
3-11/16" to
GPF475 19-7/8" 23-5/8"* 4-1/4"** 3/4"
*Bottom of panel must be notched 1-1/2" x 1/2" to clear access
panel. (See illustration above)
**Adjustment required to match adjacent cabinet fronts due to
leveling adjustment, 4" nominal.
