GE Cafe series Manual

CGY366SELSS
GE Café™Series 36" All Gas Professional Range with 6 Burners (Natural Gas)
Specification Revised 10/17
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
All GE Appliances ranges are equipped
with an Anti-Tip device. The installation
of this device is an important, required
step in the installation of the range.
Listed by
Underwriters
Laboratories
For answers to your GE Appliances product questions, visit our website
at geappliances.com or call GE Answer Center®Service, 800.626.2000.
NOTE: Professional ranges offer a number of choices
in size and cooktop configurations. All Professional
Ranges are factory set for natural gas.
NOTE: Conversion kits are included with the range.
High Altitude kit, WB28K10553 for operation above
6,000 feet (for Natural and LP gas models), is also
available. The kits must be installed by a qualified
service technician at additional cost.
INSTALLATION INFORMATION: Before
installing, consult installation instructions packed
with product or online at geappliances.com for
current dimensional data.
A suitable 36" or wider vent hood is required
for installation over ranges with a grill and
recommended for all other ranges.
ADVANCE PLANNING: Refer to dimensional
drawings for appropriate placement and necessary
clearances when planning the installation.
- Working areas adjacent to the range should have
18" minimum clearance between countertop and
cabinet bottom.
- Clearance between range and side wall or
combustible material must be at least 12" on
each side.
- Installation must conform with local codes.
In the absence of local codes, the range must
comply with the National Fuel Gas Code,
ANSI Z223.1-1990.
ADDITIONAL CLEARANCES:
Allow 12" minimum clearance to an adjacent wall
on each side.
Working areas adjacent to the rangetop should have
18" minimum clearance between countertop and
the bottom of the wall cabinet.
Non-Combustible
Material
13"
max.
18"
min.
36" min.
48" minimum
to combustibles
12" minimum
each side
12" minimum
to adjacent wall
WARNING: Installations without a hood require
48" minimum to combustibles. A custom hood
installation with exposed horizontal combustible
surfaces must have an Auto-On feature. Refer to
hood installation instructions for specific hood
clearances.
The surface of the entire back wall above the range
and below the hood must be covered with a non-
combustible material such as metal, ceramic tile,
brick, marble or other stone.
35 7/8" width
28 1/4"
35 1/4"
to
36 3/4"
height 3 1/4"
to 4 3/4"
Toekick/leg
height
Depth
to front
of door
1 1/2"
Countertop
to Cooking
Surface
CGY366SELSS
C2Y366SELSS

CGY366SELSS
GE Café™Series 36" All Gas Professional Range with 6 Burners (Natural Gas)
Specification Revised 10/17
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
All GE Appliances ranges are equipped
with an Anti-Tip device. The installation
of this device is an important, required
step in the installation of the range.
Listed by
Underwriters
Laboratories
For answers to your GE Appliances product questions, visit our website
at geappliances.com or call GE Answer Center®Service, 800.626.2000.
ELECTRICAL REQUIREMENTS: Ranges must
be hooked up to a 120V, 60Hz properly grounded
dedicated circuit protected by a 15-amp circuit
breaker or time-delay fuse.
GAS SUPPLY: The natural gas models are
designed to operate at 5" water column pressure.
For proper operation, the pressure of the natural
gas supplied to the regulator must be between 7"
and 13" water column.
The LP models are designed to operate at 10"
water column pressure. For proper operation, the
pressure of the LP gas supplied to the regulator
must be between 11" and 13" water column.
OPTIONAL BACKSPLASH ACCESSORIES:
The range requires a 12" minimum clearance
to a vertical combustible surface at the rear. A
backsplash is required for installations with less
than 12" clearance. The following backsplash
accessories are available, or a custom, non-
combustible backsplash can be used.
Order one with a 36"-wide range backsplash
UX12B36PSS – 12" backsplash
UXADJB36PSS – 30"-36" adjustable-height
backsplash with warming shelf
Universal Utility Locations
2"
G/E G/E
4 5/8"
13 3/8"
36"
11 3/8"
3" 6 1/2"
10-1/2"
1-1/2"
12"
28-1/4" to
Beveled
Edge of Control
Panel Bullnose
27-1/2" to
Beveled Edge
- Maximum
Adjacent
Cabinet Depth
for
Flush
Installation
13/16"
30-36"
3-3/16"
Control Panel
Depth
28-1/4"
to Front of
Door
48-1/4"
with Oven Door
Open
31-1/16"
to Front of
Handle
35-1/4"
to
36-3/4"
7" Control
Panel Height
28-7/8"
to Front
Edge
Optional
Backsplash
A
ccessories
SIDE VIEW WITH BACKSPLASH
UNIVERSAL UTILITY LOCATIONS

CGY366SELSS
GE Café™Series 36" All Gas Professional Range with 6 Burners (Natural Gas)
Specification Revised 10/17
BACK FRONT FRONT BACK FRONT
TIMER
PUSH TO
SELECT
O
F
F
B
A
K
E
B
R
O
I
L
P
R
O
O
F
R
O
A
S
T
B
R
O
I
L
B
A
K
E
C
O
N
V
.
C
O
N
V
.
C
O
N
V
.
BACK
CGY366SELSS
C2Y366SELSS
FEATURES AND BENEFITS
Six sealed 18,000 BTU dual stack burners - Delivers a full spectrum
of heating settings, from an ultra-low 140 F simmer to an intense
18,000 BTU flame
Professional oven system - Combines reverse-air convection
technology with an infrared broil and gas burner to provide superb
baking results, with fast preheating
Professional dual-burner bake system - Combines reverse-air
convection technology with an infrared broil and gas burner to
provide superb baking results, with fast preheating
Full-extension, heavy-duty roller rack - Glide smoothly in and out
on stainless steel ball bearings for easy access, and are designed to
remain in the oven during the self-clean cycle
Electronic ignition with automatic reignition - Ensures a
continuous flame and reignites automatically if accidentally
extinguished
Reversible burner grates - Flat on one side and uniquely contoured
on the other to accommodate round-bottom woks
6.2 cu. ft. oven capacity - Caterer's oven uniquely sized to
accommodate three full-size sheet trays
Star-K certification - Allows range to operate in Sabbath mode
Model CGY366SELSS – Stainless steel