T e Fabric Softener Compartment
If esire , pour the recommen e amount
of liqui fabric softener into the compartment
labele “FABRIC SOFTENER.”
Use only liqui fabric softener in the ispenser.
Dilute with water to the maximum fill line.
Do not exceed the maximum fill line. Overfilling
can cause early dispensing of the fa ric
softener, which could stain clothes.
NOTE: Do not pour fa ric softener directly
on the wash load.
10
Consumer Support Troubles ooting Tips Operating Instructions Safety Instructions
Installation
Instructions
About t e was er features.
T e Dispenser Drawer
Slowly open the ispenser rawer by pulling
it out until it stops.
After adding laundry products, slowly close
the dispenser drawer. Closing the drawer
too quickly could result in early dispensing
of the leach, fa ric softener or detergent.
You may see water in the leach and fa ric
softener compartments at the end of the cycle.
This is a result of the flushing/siphoning action
and is part of the normal
operation of the washer.
Use only HE Hig -Efficiency
detergent.
T e Liquid Bleac Compartment
If esire , measure out the recommen e
amount of liqui bleach, not to excee
1/3 cup (80 ml) an pour into the center
compartment labele “LIQUID BLEACH”
marke with this symbol .
It is recommended to use High-Efficiency (HE)
leach in this front-load washer.
Do not exceed the maximum fill line. Overfilling
can cause early dispensing of the leach which
could result in damaged clothes.
NOTE: Do not use powdered leach in the
dispenser.
T e Detergent Compartment
■Only use high-efficiency detergent
in this washer. Use the detergent
manufacturer’s recommended amount.
DO NOT fill above the MAX line.
The etergent selection insert must be place
in the etergent compartment in a specific
position accor ing to the type of etergent
you are using.
■Powder Detergent – Place the insert
in the rear position. The Pow er Icons
must line up on center when the insert
is in the pow er position.
■Liquid Detergent – Place the insert in
the forwar position. The Liqui Icons
must line up on center when the insert
is in the liqui position.
Move the insert by pulling it up an replace
it by sli ing it own between either the rear
or front etergent compartment mol e rails,
as esire , for pow er or liqui etergent.
■A measure etergent to the front left
etergent compartment of the ispenser
rawer.
■Detergent is flushe from the ispenser
at the beginning of the wash cycle. Either
pow ere or liqui etergent can be use .
■Detergent usage may nee to be a juste
for water temperature, water har ness,
size an soil level of the loa . Avoi using
too much etergent in your washer as it
can lea to oversu sing an etergent
resi ue being left on the clothes.
Insert in rear position for powder
detergent
Insert in forward position for liquid
detergent
T e Prewas Compartment
■Only use the Prewash Compartment if you
are selecting the Prewash cycle for heavily
soile clothes. A measure etergent or
prewash a itive to the back left prewash
compartment of the ispenser rawer.
■Detergent or prewash a itive is flushe
from the ispenser in the prewash cycle
(if selecte ).
NOTE: Liquid detergent will drain
into the washer drum as it is added.
■Detergent usage may nee to be a juste
for water temperature, water har ness, size
an soil level of the loa . Avoi using too
much etergent in your washer as it can
lea to over su sing an etergent resi ue
being left on the clothes.
Liquid
Icons
Powder
Icons
