Gear Light S1000 User manual

S1000 LED HEADLAMP
Operation Guide
TROUBLESHOOTING
If the headlamp does not turn on, or works intermittently:
Replace the batteries.
Ensure the AAA batteries are inserted correctly according to the polarity (-,+)
marked on the battery holder.
Make sure the AAA battery holder is inserted correctly and secured.
If the light appears dim or faded:
Irvine, California | USA | www.GearLight.com
WARRANTY AND LIMITATION OF LIABILITY
MAINTENANCE
Inspect the headlamp monthly and carefully remove any damaged batteries and
clean any corrosion. If the headlamp is used less than once a month, remove the
batteries between uses.
Limited One-Year Warranty
GearLight warrants this product for one year from the date of purchase
against any defects in material or workmanship. This warranty does not cover
normal wear and tear, nor damage resulting from misuse or neglect. We will,
at our discretion, repair, replace, or refund the purchase price of this product
should we determine it to be defective.
Limitation Of Liability
Liability limited to the purchase price of this product. GearLight shall not be
liable for any incidental or consequential damages or any implied warranty on
this product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
If the problem persists, possible LED Failure. Contact GearLight for a replacement.
Replace the batteries.
1x GearLight S1000 LED Headlamp
1x AAA Battery Holder (Inside Battery Compartment)
3x AAA Batteries
1x Operation Guide
1x Warranty Card
Package Contents:
IMPORTANT SAFETY NOTICE: Lithium-ion batteries are potentially hazardous and can present a
fire, explosion, and burn hazard. By using lithium-ion batteries, you agree that GearLight shall not
be liable for any incidental or consequential damages arising from, relating to or connected with the
use of lithium-ion batteries. If you do not agree with these conditions, please use only alkaline or
NiMH rechargeable batteries.
FOR YOUR SAFETY, READ BEFORE OPERATING
V2

WARNING:To avoid eye injury, do not stare directly into the light beam or shine the beam directly into
anyone’s eyes. Keep out of the reach of children. CAUTION: The headlamp may become warm or hot after extended periods of
use at the highest setting. Select a lower setting when the headlamp is hot.
WARNING: Batteries can explode or leak and cause injury if installed backwards,
disassembled, charged, crushed, mixed with used or other battery types, or exposed
to fire or extreme temperatures. Replace all batteries at the same time. Never install
a defective battery in the headlamp. Failure to follow safety instructions may result in
personal injury or damage to property.
AAA Battery Installation
1. Insert 3 AAA batteries following the correct
polarity (+,-) marked on the battery holder.
2. Insert the battery holder back into the battery
compartment with the correct polarity.
3. Replace the rubber cover, making sure that the
cover is placed evenly over the rim of the case.
On/O
To turn the headlamp on, press down firmly on the red power button located
on the side of the headlamp until you hear a click.
To turn the headlamp o, press down firmly again to cycle through the
dierent modes until the headlamp turns o.
Switching Modes
There are 4 dierent lighting modes. (High, Low, Strobe,
SOS)
To switch through the dierent lighting modes, press
down firmly on the red power button to alternate through
the 3 modes.
To access the SOS mode, press and hold the red power
button for 3 seconds.
GETTING STARTED
OPERATION
ELASTIC
HEADSTRAP
3 ADJUSTABLE
BUCKLES
HEAD
90 ROTATING
HEAD
BATTERY
COMPARTMENT
ZOOMABLE
DESIGN
POWER
BUTTON
HEAD STRAP ADJUSTMENT
To adjust the S1000 headlamp to fit your head, slide the buckles on the elastic
headstraps.
90 Rotating Head (Fig. 1)
90
Tilt the head up or down within a 90-degree angle to aim the light where it is
needed.
Zoom (Fig. 2)
1. Pull the head of the headlamp away to zoom in.
2. Push the head of the headlamp in to zoom out.
Fig. 1 Fig. 2
90 Rotating Head Zoom
18650 Lithium-ion Rechargeable Battery Installation
(See Warning)
1. Insert one 18650 battery following the correct
polarity (+,-) marked on the battery compartment.
2. Replace the rubber cover, making sure that
the cover is placed evenly over the rim of the case.
WARNING: Lithium-ion batteries can present a fire, explosion, and burn hazard. Use
only 18650 battery cells with a protection circuit produced by Panasonic, Sanyo, Sony,
Samsung, or LG. Remove the battery when the headlamp is not in use. The use of
other cell manufacturers or the failure to follow the battery manufacturer's safety
instructions may result in fire, explosion, personal injury, and damage to property.
Li-ion 18650
+
+
+
Note: To access the battery compartment, pull the rubber cover slightly away from
the battery compartment.