Gear Light V500 User manual

Operation Guide
FOR YOUR SAFETY, READ BEFORE OPERATING
Package Contents:
WARRANTY AND LIMITATION OF LIABILITY
MAINTENANCE
Inspect the headlamp monthly and carefully remove any damaged batteries and
clean any corrosion. If the headlamp is used less than once a month, remove the
batteries between uses.
Limited One-Year Warranty
GearLight warrants this product for one year from the date of purchase
against any defects in material or workmanship. This warranty does not cover
normal wear and tear, nor damage resulting from misuse or neglect. We will,
at our discretion, repair, replace, or refund the purchase price of this product
should we determine it to be defective.
Limitation Of Liability
Liability limited to the purchase price of this product. GearLight shall not be
liable for any incidental or consequential damages or any implied warranty on
this product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion
may not apply to you.
If the problem persists, possible LED Failure. Contact GearLight for a replacement.
Replace the batteries.
TROUBLESHOOTING
If the headlamp does not turn on, or works intermittently:
Replace the batteries.
Ensure the AAA batteries are inserted correctly according to the polarity (-,+)
marked on the battery compartment.
Make sure the battery compartment is closed tightly and securely.
Firmly press the power button on and o several times.
If the light appears dim or faded:
Irvine, California | USA | www.GearLight.com
2x GearLight V500 LED Headlamps
1x Operation Guide
1x Warranty Card
V500 LED HEADLAMP
v2

• Tilt the headlamp down to adjust the beam angle and aim the light where it
is needed.
Switching Modes
• To turn the headlamp on, press down firmly on one of the power buttons
located on the top of the headlamp until you hear a click.
• To turn the headlamp o, press the same power button again to cycle through
the dierent modes until the headlamp turns o.
On/O
OPERATION
CAUTION: The headlamp may become warm or hot after extended periods of
use at the highest setting. Select a lower setting when the headlamp is hot.
GETTING STARTED
WARNING:To avoid eye injury, do not stare directly into the light beam or shine the beam directly into
anyone’s eyes. Not to be used by children except under adult supervision.
MEDIUMHIGH STROBE
SPOT FLOOD
LOW STROBE
RED
LOW
• There are 6 dierent lighting modes:
Spot Light Mode: High, Medium, Strobe
Flood Light Mode: Low
Red Light Mode: Low, Strobe
• To activate the spot light, press down firmly on the right side of the power
button . Press the power button again to cycle through the 3 modes.
• To activate the flood light, press down firmly on the left side of the power
button .
• To activate the red light, press down firmly on the left side of the power
button twice. Press the power button again to cycle through the 2 modes.
Fig. 6
Adjustable Light Angle (Fig. 6)
• Attach the elastic head strap according to Fig. 4 and Fig. 5 below.
• Adjust the length of the head strap to fit your head comfortably.
• To loosen or tighten the head strap, simply slide the plastic strap adjuster forward or
backward. Fig. 4 Fig. 5
Fig. 1
Fig. 2 Fig. 3
AAA Battery Installation (Fig. 2-3)
1. Insert 3 AAA batteries following the correct
polarity (+,-) marked on the battery holder.
2. Close the battery compartment until the latch
clicks into place.
Opening the Battery Compartment (Fig. 1)
1. To access the battery compartment, tilt the
headlamp down.
2. Use one hand to hold the left side, and the other
hand to lift the latch.
FLOOD & RED LIGHT
POWER BUTTON
FLOOD LED
STRAP
ADJUSTERS
BATTERY
COMPARTMENT LATCH
SPOT LIGHT
POWER BUTTON
ELASTIC
HEAD STRAP RED LED
SPOT LED
HEAD STRAP ADJUSTMENT
WARNING: Always follow the battery manufacturer’s instructions as to the proper
usage, handling, storage, and disposal of batteries. Use only batteries from a reputable
manufacturer. Do not mix dierent brands or types of batteries in the same flashlight.
Replace all batteries at the same time. Failure to follow safety instructions may result
in personal injury and damage to property.