geetek Boost-N User manual

-GEETEK Boost-N Router Unit
-2 x 5dBi Antenna (RP-SMA Connector)
-Power AC Adapter
-RJ45 Ethernet Cable
-QIG & Manual CD
Before installing the router, connect your PC to the internet through your broadband service. (If there
is any problem, contact your ISP.)Then proceed through the following steps.
1. Turn off your PC(s), cable/ ADSL modem and the router.
2. Adjust the antenna if needed. Normally, straight up on router is good.
3. Connect the PC(s) and each switch/hub on your local area network to the LAN ports on the
router.
4. Connect the ADSL/DSL/cable modem to the router WAN port.
5. Connect the power adapter between the DC-Jack on the router and an electrical outlet. The
router will start to work automatically.
6. Turn on your PC(s) and the cable/ADSL modem.

.

The AP Router is delivered with the following factory default parameters on the Ethernet LAN
interfaces.
Default IP Address: 192.168.1.254
Default IP subnet mask: 255.255.255.0
Web login User Name: <empty>
Web login Password: <empty>
The device has three operation modes (Gateway/Bridge/WISP).
The default IP addresses for the device are 192.168.1.254, so you need to make sure the IP address
of your PC is in the same subnet as the device, such as 192.168.1.X.
It will take about 55 seconds to complete the boot up sequence after power on.