Gefen COMPAUD-141 User manual

Component
w/ Audio Extender
USER MANUAL
www.gefen.com

Technical Support:
Telephone [phone]
[phone]
Fax [phone]
Technical Support Hours:
8:00 AM to 5:00 PM Monday thru Friday PST
Write To:
Gefen Inc.
C/O Customer Service
20600 Nordhoff St
Chatsworth, CA 91311
www.gefen.com
[email protected]
Notice
Gefen Inc. reserves the right to make changes in the hardware, packaging and any
accompanying documentation without prior written notice.
Component w/ Audio Extender is a trademark of Gefen Inc.
© 2007 Gefen Inc., All Rights Reserved
ASKING FOR ASSISTANCE

TABLE OF CONTENTS
INTRODUCTION / HOW IT WORKS / OPERATION NOTES
FEATURES
PANEL DESCRIPTION
PANEL DESCRIPTION
INSTALLATION INSTRUCTIONS / HOW TO ADJUST THE PICTURE
CAT5 WIRING DIAGRAM
SPECIFICATIONS
WARRANTY
1
2
3
4
5
6
7
8

Thank you for purchasing the Component with Audio Extender by Gefen, Inc.
Extend your audio and video signal using the Gefen Component Audio Extender. Place
your source anywhere and extend the signal up to 1000 feet (300 meters) away. The
Component Audio Extender will extend Analog Component as well as Analog Audio and
Digital Audio via SPDIF or TOSlink.
INTRODUCTION
1
READ THESE NOTES BEFORE INSTALLING
OR OPERATING THE COMPONENT EXTENDER SYSTEM
• Use industry standard Category-5e (CAT-5e) cable to operate the Component with
Audio Extender system. CAT-5e cable is preferred.
• Please connect all the cables between the source and the Component with Audio
Extender before powering up the Component with Audio Extender unit.
• The Component with Audio Extender units are housed in a metal box for better RF
shielding.
OPERATION NOTES
HOW IT WORKS
The Component Audio Extender sender unit connects to any component video and audio
source using the supplied Component and RCA cables. The receiver unit connects to your
HDTV component video display and audio input up to 1000 feet (300 meters) away. One
CAT-5e cable is used to connect the sender to receiver for perfect video extension up to
1080p. The sender and receiver will be powered individually by 5V power supplies.

Features
• Supports up to 1080p component video
• Supports analog L+R audio
• Plug and play installation
• Equalizations for different CAT-5 skews
• One CAT-5 cable for extension
Includes:
(1) Component Audio Extender Sender
(1) Component Audio Extender Receiver
(1) 6ft. Component Cable
(1) RCA Audio Cable
(2) 5V Power Supply
FEATURES
2

PANEL DESCRIPTIONS
5V Power
Supply Input Component
Input
Analog Audio
Input
SPDIF Input
Optical /
Toslink Input
Power Light
Indicator
3
Sender
5V Power
Supply Input Component
Output
Analog Audio
Output
SPDIF Output
Optical /
Toslink Output
Power Light
Indicator
Receiver

CAT-5e
Cable Input
CAT-5e
Cable Input
Brightness
Trim Pot
Focus
Trim Pot
PANEL DESCRIPTIONS
4
Sender
Receiver

Connect the Component output of your source / receiver to the input on the
Component Extender Sender Unit.
Connect the audio output of your source / receiver to the input on the Component
Extender Sender Unit.
Connect the Component input of your display to the Component output on the
Component Extender Receiver Unit.
Connect the audio input of your display to the Component output on the
Component Extender Receiver Unit.
Connect a CAT-5 cable between the Component Extender sender and receiver’s
CAT-5 input.
Power on the display rst and then the source.
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
5
Note: Any of the 3 RCA lines can be used for any color. Both ends will need to be
matched for the signal to be passed through correctly.
BRIGHTNESS AND FOCUS TRIM PODS
If your picture is too dark or if you see a “ghosting” effect on your display, then the trim
pods will help correct this problem. If your picture is too dark then the brightness trim
pod will help brighten up your display. If your picture has a “ghosting” effect and/or
noise, then the focus trim pod will help sharpen up your picture. Turn trim pods to the
left and right to eliminate any noise on your picture.

White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
RJ-45 Jack RJ-45 Jack
2 3 4 5
6
7 8 1
2 3 4 5
6
7 8 1
1818
CAT5 WIRING DIAGRAM
6

Video Amplier Bandwidth....................................................................................350 MHz
Actual Bandwidth...................................................................................................120MHz
Input Video Signal...........................................................................................1.2 Volts p-p
Input Sync Signal.....................................................................................5 Volts p-p (TTL)
Horizontal Frequency Range.............................................................................15-70 KHz
Vertical Frequency Range..................................................................................30-170 Hz
Video In/Out...........................................................................................3 RCA component
Audio In/Out...................................................................2 RCA Audio, 1 SPDIF, 1 TOSlink
Link Connector...........................................................................................RJ-45 Shielded
Power Supply...........................................................................................................5V DC
Power Consumption.....................................................................................5 watts (max.)
Dimensions..........................................................................................3”W x 1”H x 3.75”D
Shipping Weight.........................................................................................................3 lbs.
SPECIFICATIONS
7