Gefen EXT-USB-MINI2N User manual

®
Mini USB-2
Extender
EXT-USB-MINI2N
USER MANUAL
www.gefen.com

ASKING FOR ASSISTANCE
Rev A1
Technical Support:
Telephone [phone]
[phone]
Fax [phone]
Technical Support Hours:
8:00 AM to 5:00 PM Monday thru Friday PST
Write To:
Gefen, LLC
c/o Customer Service
20600 Nordhoff St
Chatsworth, CA 91311
www.gefen.com
[email protected]
Notice
Gefen, LLC reserves the right to make changes in the hardware, packaging, and
any accompanying documentation without prior written notice.
Mini USB-2 Extender is a trademark of Gefen LLC
© 2013 Gefen, LLC. All rights reserved.
All trademarks are the property of their respective owners.

CONTENTS
1 Introduction
2 Operation Notes
3 Features
4 Sender Panel Layout
5 Sender Panel Descriptions
6 Receiver Panel Layout
7 Receiver Panel Descriptions
8 Connecting And Operating The Mini USB-2 Extender
9 Network Cable Wiring Diagram
10 Specications
11 Warranty

1
Congratulations on your purchase of the Mini USB-2 Extender. Your complete
satisfaction is very important to us.
Gefen
Gefen delivers innovative, progressive computer and electronics add-on solutions
that harness integration, extension, distribution and conversion technologies.
Gefen’s reliable, plug-and-play products supplement cross-platform computer
systems, professional audio/video environments and HDTV systems of all sizes
with hard-working solutions that are easy to implement and simple to operate.
The Gefen Mini USB-2 Extender
The Gefen Mini USB-2 Extender allows the extension of any USB 1.1 device up
to 150 feet (45 meters). The Receiver comes with a 2-port USB HUB.
This extender exceeds the 16-feet distance limitation of USB extension by using
Extreme USB technology to extend USB up to 150 feet (45 meters) away from
the computer. This solution is ideal for applications where two USB devices, such
as a keyboard and mouse, must be operated remotely but is also useful with
most other USB-based devices.
How It Works
Connect the Sender unit to the USB source using the included USB cable.
Place the Receiver unit up to 150 feet (45 meters) away from the USB source.
Use a single CAT-5e cable to connect the Sender unit to the Receiver unit.
Connect up to two USB devices to the Receiver unit.
INTRODUCTION

READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE MINI USB-2 EXTENDER
• CAT-5e or CAT-6a cables should not exceed 150 feet (45 meters).
• Shielded (STP) CAT-5e or CAT-6a is recommended. However, un-shielded
(UTP) CAT-5e or CAT-6a is acceptable.
• The Sender and Receiver unit are powered by the source.
2
OPERATION NOTES
NOTE: The shielded cable has an advantage by providing
immunity to Electromagnetic Interference (EMI), cell
phones and A/C motors.

3
Features
• Extends any USB 1.1 device up to 150 feet (45 meters) using CAT-5 cable
• Provides support for any full-speed 12 Mb/s or low-speed 1.5Mb/s USB
device
• Provides two USB outputs
• Supports Windows XP, Windows Vista, Windows 7, Linux, and Mac OSX
operating systems
• Requires no external power adapter, powered by the USB bus
Package Includes
(1) Mini USB-2 Extender - Sender Unit
(1) Mini USB-2 Extender - Receiver Unit
(1) 6 ft. USB Cable (A - B)
(1) Quick-Start Guide
FEATURES

4
Front
Back
SENDER UNIT LAYOUT
1
2

5
1 USB Input
Connect the USB source to this port using the supplied USB cable
2 CAT-5
Connects the Sender to the Receiver unit using a CAT-5e cable
SENDER UNIT DESCRIPTIONS

6
Front
Back
RECEIVER UNIT LAYOUT
1
3
2

7
1 USB Output
Connects a USB device (i.e mouse, keyboard, hub)
2 USB Output
Connects a USB device (i.e mouse, keyboard, hub)
3 CAT-5
Connects the Sender to the Receiver unit using a CAT-5e cable
RECEIVER PANEL DESCRIPTIONS

8
How to Connect the Mini USB-2 Extender
1. Using the included USB cable, connect the source to the USB input port on
the Sender unit.
2. Connect a CAT-5e cable from the Sender to the Receiver unit up to 150 feet
(45 meters) away.
NOTE: Ifterminatingnetworkcablesintheeld,pleaseadhereto
theTIA/EIA568Bspecication(seepage9).
3. Up to two USB devices can be connected to the USB outputs on the
Receiver unit.
CONNECTING AND OPERATING THE MINI USB-2 EXTENDER
EXT-USB-MINI2N
USB CABLE
CAT5 CABLE
Sender
Computer
Receiver
USB Peripheral
USB Peripheral
IMPORTANT: This product cannot be disposed of in the general
trash. Please contact your solid waste local authority.

12345678
GefenhasspecicallyengineeredtheirproductstoworkwiththeTIA/EIA-568-B
specication.Pleaseadheretothetablebelowwheneldterminatingcablefor
use with Gefen products. Failure to do so may produce unexpected results and
reduced performance.
CAT-5, CAT-5e, and CAT-6 cabling comes in stranded and solid core types.
Gefen recommends using solid core cabling.
Each cable run must be one continuous run from one end to the other. No splices
or use of punch down blocks.
Pin Color
1 Orange / White
2 Orange
3 Green / White
4 Blue
5 Blue / White
6 Green
7 Brown / White
8 Brown
9
NETWORK CABLE WIRING DIAGRAM

10
USB Connector (Sender)...................................................(1) USB Type B, female
USB Connector (Receiver................................................. (2) USB Type A, female
Link Connectors (Sender/Receiver)......................................................... (1) RJ-45
USB Current Output..................................................Up to 400mA per USB device
(as long as the host can provide 800mA or more)
Operating Temperature.............................................. +32 to +122 °F (0 to +50 °C)
Dimensions (W x H x D) (Sender/Receiver)..................................3.5” x 0.9” x 2.2”
(85mm x 22mm x 55mm)
Shipping Weight..................................................................................1 lb (0.45 kg)
SPECIFICATIONS

11
WARRANTY
Gefen warrants the equipment it manufactures to be free from defects in material
and workmanship.
IfequipmentfailsbecauseofsuchdefectsandGefenisnotiedwithintwo(2)
years from the date of shipment, Gefen will, at its option, repair or replace the
equipment, provided that the equipment has not been subjected to mechanical,
electrical,orotherabuseormodications.Equipmentthatfailsunderconditions
other than those covered will be repaired at the current price of parts and labor in
effect at the time of repair. Such repairs are warranted for ninety (90) days from
the day of reshipment to the Buyer.
This warranty is in lieu of all other warranties expressed or implied, including
withoutlimitation,anyimpliedwarrantyormerchantabilityortnessforany
particular purpose, all of which are expressly disclaimed.
1. Proof of sale may be required in order to claim warranty.
2. Customers outside the US are responsible for shipping charges to and from
Gefen.
3. Copper cables are limited to a 30 day warranty and cables must be in their
original condition.
The information in this manual has been carefully checked and is believed to
be accurate. However, Gefen assumes no responsibility for any inaccuracies
that may be contained in this manual. In no event will Gefen be liable for
direct, indirect, special, incidental, or consequential damages resulting from
any defect or omission in this manual, even if advised of the possibility of such
damages. The technical information contained herein regarding the features and
specicationsissubjecttochangewithoutnotice.
For the latest warranty coverage information, refer to the Warranty and Return
Policy under the Support section of the Gefen Web site at www.gefen.com.
PRODUCT REGISTRATION
Please register your product online by visiting the Register Product page
under the Support section of the Gefen Web site.

Rev A1
Pb
20600 Nordhoff St., Chatsworth CA 91311
1-800-545-6900 818-772-9100 fax: [phone]
www.gefen.com [email protected]