Gefen DIGAUD-141 User manual

Digital Audio
Extender
USER MANUAL
www.gefen.com

Technical Support:
Telephone [phone]
[phone]
Fax [phone]
Technical Support Hours:
8:00 AM to 5:00 PM Monday thru Friday.
Write To:
Gefen Inc.
c/o Customer Service
20600 Nordhoff St.
Chatsworth, CA 91311
[email protected]
www.gefen.com
Notice
Gefen Inc. reserves the right to make changes in the hardware, packaging and any
accompanying documentation without prior written notice.
The Digital Audio Extender is a trademark of Gefen Inc.
© 2007 Gefen Inc., All Rights Reserved
ASKING FOR ASSISTANCE

TABLE OF CONTENTS
Introduction
Box Contents
How to Connect the Digital Audio Extender
Link Cable - Wiring Diagram
System Specifications
Warranty
1
2
3
4
5
6

Thank you for purchasing the new ex•tend•it Digital Audio Extender series.
Extends S/PDIF and TOSLINK digital audio devices up to 60 meters (200 feet).
Place your digital audio components anywhere you want with Gefen’s DigitalAudio
Extender. It supports either S/PDIF or TOSLINK digital audio signals, which commonly
used to transmit stereo and multichannel (7.1, DTS, Dolby Digital, etc.) digital audio.
The Digital Audio Extender uses a sender and receiver system connected by CAT-5E
cables to extend the digital audio.
How It Works
The Digital Audio Extender’s sender unit connects to the audio source component. The
Digital Audio Extender’s receiver unit connects to the extended audio component (up to
200 feet away). One CAT-5E cable connects the sender to the receiver.
INTRODUCTION
1

The Digital Audio Extender system consists of:
(1) Digital Audio Extender
(1) 5 VDC power supply
(1) TOSLINK Cable (6 FT M-M)
(1) User Manual
BOX CONTENTS
2
READ THESE NOTES BEFORE INSTALLING
OR OPERATING THE DIGITAL AUDIO EXTENDER SYSTEM
* Industry standard Category-5 (CAT-5) cables are used to link the Digital Audio Extender
sender and receiver boxes together.
* The Digital Audio Extender units are housed in a metal box for better RF shielding.
OPERATION NOTES

HOW TO CONNECT THE DIGITAL AUDIO EXTENDER
3
How to Connect the Digital Audio Extender
1- Connect your digital audio source device with either TOSLINK or S/PDIF to the
Digital Audio Extender sender unit.
2- Connect the CAT5 cable from the send unit to the receive unit.
3- Connect your digital audio receiver or digital audio speaker to the Digital Audio Ex-
tender receiver unit with TOSLINK or S/PDIF. The DigitalAudio Extender supports out-
puts via TOSLINK or S/PDIF simultaneously.
4- Plug the 5 volt power supply into the Audio extender send unit.

LINK CABLE - WIRING DIAGRAM
4
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
RJ-45 Jack RJ-45 Jack
2 3 4 5
6
7 8 1
2 3 4 5
6
7 8 1
1818

Data Transmission Rate ................................................................................. 12.8 Mbp/S
Input/Output ...................................................... S/PDIF (Digital Coax), Optical TOSLINK
Power Supply ......................................................................................... 5 VDC (External)
Dimensions ........................................................................... 1 1/4”H x 1 1/2”W x 3 7/8”D
Weight ....................................................................................................................... 4 lbs
SPECIFICATIONS
5

Gefen Inc. warrants the equipment it manufactures to be free from defects in material
and workmanship.
If equipment fails because of such defects and Gefen Inc. is notified within two
(2) year from the date of shipment, Gefen Inc. will, at its option, repair or replace
the equipment, provided that the equipment has not been subjected to mechanical,
electrical, or other abuse or modifications.
Equipment that fails under conditions other than those covered will be repaired at the
current price of parts and labor in effect at the time of repair. Such repairs are warranted
for ninety (90) days from the day of reshipment to the Buyer.
This warranty is in lieu of all other warranties expressed or implied, including without
limitation, any implied warranty or merchantability or fitness for any particular purpose,
all of which are expressly disclaimed.
1. Proof of sale may be required in order to claim warranty.
2. Customers outside the US are responsible for shipping charges to and from Gefen.
3. Copper cables are limited to a 30 day warranty and cable must be free from any
scratches, markings, and neatly coiled.
The information in this manual has been carefully checked and is believed to be
accurate. However, Gefen Inc. assumes no responsibility for any inaccuracies that
may be contained in this manual. In no event will Gefen Inc., be liable for direct,
indirect, special, incidental, or consequential damages resulting from any defect
or omission in this manual, even if advised of the possibility of such damages. The
technical information contained herein regarding Digital Audio Extender features and
specifications is subject to change without notice.
WARRANTY
6