Gelmar Tandem Larder Unit User manual

STEP 8
Install the runner protective cover.
STEP 7
Adjust the L-shaped bracket with the castors, make sure the castors are
put into the U-shaped slot completely and tighten the screws with a
screw reamer.
Installation Continued... STEP 10
Screw the screws out of the connecting strip, as the sequence revealed
in the picture, connect the slip frame and the top of the panel hangstrip
with the connecting strip (Attention: The connecting strip has the
dierentiation from left and right), and tighten the screws.
STEP 9
Install panel hangsrip.
STEP 11
Screw the screws out of the connecting strip, as the sequence revealed
in the picture, connect the slip frame and the bottom of the panel
hangstrip with the connecting strip (Attention: The connecting strip has
the dierentiation from left and right), and tighten the screws.
90
90
DIY Installation Guide
Tandem Larder
Unit
Cabinet Z
450 / 500 315

Tandem Larder Unit Installation
1 x U-Iron
1 x L-shaped Bracket
1 x Pair Runners
2 x Connection Strip
2 x Runner
Protective Cover
Code Unit Size (U) kg Finish Material
6297 450 / 500 50kg CP Steel
16 x ST3.5
Tapping Screw
2 x L-shaped Iron
25 x ST3.5
Tapping Screw
H
min. 418
min. 580
max
Unit Size
450 / 500
max
Interior height
1750 - 2065
STEP 1
As the size revealed in the picture below, drill 4 small holes
Ø2.5mm respectively on the top cabinet panel.
STEP 2
As the size revealed in the picture below, drill 12 small holes
Ø2.5mm respectively on the bottom cabinet panel.
STEP 5
Fix the runners onto the bottom frame panel with the 12pcs tapping
screws ST3.5x16.
STEP 3
Install L-shaped iron.
Tighten the screw
through the hole
STEP 4
A: Screw the loaded screws out of the slip frame, attach L-shaped
bracket with castors into the frame tube as illustrated in the picture and
screw up the screws but it is not necessary to tighten them.
B: Fix the frame installed in step A to the L-shaped iron sheets with 4
screws M6x25.
The frame can be turned around to accommodate for a left or right
opening cabinet.
STEP 6
Fix the U-iron onto the cabinet top with 4 tapping screws ST3.5x16.
Cabinet X
450 / 500 178.5
Cabinet Y
450 / 500 285
We recomend that you install a shelf at the top of your cabinet,
creating more storage space and reducing the extension height of
the L-shaped bracket