Gemmy Projection User manual
E-1
SAFETY WARNING: Remove all plastic fasteners and tags. These are part of
the packaging and should be discarded.
SAVE THESE INSTRUCTIONS –This manual contains important safety
and operating instructions for power units.
WARNING
WARNING
Strobe lights have been known to trigger seizures in people with photosensitive epilepsy.
WARNING
The light is very bright. Do not shine directly into eyes.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING(THIS FURNISHING)
WARNING: TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC SHOCK
OR INJURY TO PERSONS ：
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
Do not let lamps rest on the supply cord or on any wire.
Do not close doors or windows on the product or extension cords as this may damage the wire insulation.
Do not cover the product with cloth, paper or any material not part of the product when in use.
Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When products are used in outdoor
applications, connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not provided, contact a qualified
electrician for proper installation.
This seasonal use product is not intended for permanent installation or use.
Do not mount or place near gas or electric heaters, fireplace, candles or other similar sources of heat.
Unplug the product when leaving the house, when retiring for the night, or if left unattended.
This is an electric product-not a toy! To avoid risk of fire, burns, personal injury and electric shock it should not be played with
or placed where small children can reach it.
Do not use this product for other than its intended use.
Do not hang ornaments or other objects from cord, wire, or light string.
This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows,
unplug the product from the outlet. Also unplug any additional strings or products that may be attached to the product. Replace
the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the
replacement fuse blows, a short-circuit may be present and the product should be discarded.
This product has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug
will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not use with an extension cord unless plug can be fully inserted. Do not alter or replace.
Read and follow all instructions that are on the product or provided with the product.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
INSTRUCTIONS
E
ELECTRIC PRODUCT. Keep away from children. As with all electrical products, precautions should
be observed during handling and use to reduce the risk of electric shock. If the supply cord is
damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
E-2
CAUTION: To reduce the risk of fire and electric shock:
1. Do not install on trees having needles, leaves or branch coverings of metal or materials which look like metal.
2. Do not mount or support wires in a manner that can cut or damage wire insulation.
SAVE THESE INSTRUCTIONS.
TECHNICAL SPECIFICATIONS
ASSEMBLY INSTRUCTIONS
1. Assemble the light stake parts A & B as shown in illustration 1. Push the A and B parts together
until tighten the screws.
2. Push A through the circle,insert the grooves of projection ,and tighten the circle,then adjust the
angle of projection . (See illustration 1)
TM
TM
Plug power cord into standard wall socket. (See illustration 2)3.
4. Unplug when not in use.
USER SERVICING INSTRUCTIONS
Fuse Replacement
WARNING: Risk of Fire: Replace only with same size and type of fuse.
WARNING: Risk of Fire: Do not replace the attachment plug. Contains a safety
device (fuse) that should not be removed. Discard product if
attachment plug is damaged.
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on the cord.
illustration 1
illustration 2
A
B
1pc
Stake
2pcs
Fuse
1pc
TM
Projection
Working
Fuse
Replace
Fuse
TM
E-3
Open fuse cover. Slide open the fuse access cover on top of the attachment plug towards blades.(See illustration)2.
3. Remove fuses carefully.
4. Replace fuse only with 5 Amp Max,125 Volt fuse.(provided with product)
5. Close the fuse cover.Slide closed the fuse access cover on top of the attachment plug.
OPERATING DETERMINATIONS
This product was designed for indoor and outdoor use.
Do not shake the device. Avoid brute force when operating the device.
Keep away from direct insulation (particularly in cars) and heaters.
Do not permit operation by persons not qualified to operating the device. Most damages are the result of unprofessional
operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Unauthorized modifications on the device are unacceptable due to safety reasons!
If this device is operated in any way different from the ways described in this manual, the product may suffer
damages and the guarantee becomes void.
OPERATION
- Insert the plug into socket.
- Set this device as a projection .
- Extrt the plug if not in use. Be careful with the power cord!
WARNING
• The device is for indoor and outdoor use!
• Suitable for outdoor use!
• Please keep away from heaters and other heating sources!
IMPORTANT
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not accept liability for any resulting
defects or problems. Keep away from heaters and other heating sources! If the device has been exposed to drastic temperature
fluctuation (e.g. after transportation), do not switch it on immediately. Leave the device switched off until it has reached room
temperature. Please note that damages caused by manual modifications on the device or unauthorized operation by unqualified
persons are not subject to warranty. Keep young children and amateurs away from the device!
USE AND CARE INSTRUCTIONS
WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
1. When the product is placed on a live tree, the tree should be well maintained and fresh. Do not place on live trees in
which the needles are brown or break off easily. Keep the tree holder filled with water.
2. If the product is placed on a tree, the tree should be well secured and stable.
3. Before using or reusing, inspect product carefully. Discard any products that have cut, damaged, or frayed wire
insulation or cords, cracks in the lampholders or enclosures, loose connections, or exposed copper wire.
4. When storing the product, carefully remove the product from wherever it is placed, to avoid any undue strain or stress
on the product conductors, connections, and wires.
5. When not in use, store neatly in a cool, dry location protected from sunlight.
E-4
Visit
WWW.GEMMY.COM
for more information.
©2018 GEMMY INDUSTRIES CORP.
117 WRANGLER DRIVE. SUITE 100
COPPELL, TX 75019 U.S.A.
1 (877) 250-9032
MADE IN CHINA
PRINTED IN CHINA
THESE INSTRUCTIONS ARE FOR THESE ITEMS
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
.annetnagniviecerehtetacolerrotneiroeR
•
• Increase the distance between the equipment and receiver.
.detcennocsireviecerehthcihwottahtmorftnereffidtiucricanoteltuonaotnitnempiuqeehttcennoC•
ToidardecneirepxenarorelaedehttlusnoC• V technician for help.
40091 40700 41533 71992 74163 74164 74212
74228 74232 74268 74285 74286 74287 74294
74311 74334 74343 74372 74375 74377 74527
74651 74659 74690 74692 74694 74752 74753
74754 74755 74756 74803 74805 74867 74945
74963 75026 75114 75116 75223 75438 75439
85765 85767 85768 86085 86102 86115 86135
86267 110071 110135 110137 110139 110141 110143
110145 110265 110276 110277 110327 110329 110529
110530 110531 110532 110536 110646 110751 110801
110868 110870 110927 110992 111261 111418 111419
111420 111716 111813 111814 111988 111989 111990
111991 111992 111993 112504 112612 113101 113189
113190 113441 113528 113671 113771 113880 220378
220379 220815 220816 220866 220992 221211 221233
221241 221245 221299 221313 221314 221336 221386
221430 221434 221539 221543 221544 221545 221546
221564 221570 221702 221790 221867 221883 221884
221885 221889 330055 330058 440044 440138 440171
445042 445043 445050 445064 445065 445112 445131
445132
Table of contents
Other Gemmy Projector manuals
