General Shale STACKER 150 Woodbox User manual

“Stacker 150” Woodbox (WBX-150) Assembly Instructions
STACKER 150
Woodbox
How-To Assemble Your
All General Shale Outdoor Living products are warranted to be made from high quality materials that meet or exceed ASTM material standards.
Outdoor Living products are intended for recreational or residential use and are not warranted for any other purpose. The life of the product
depends on correctness of installation and extent of usage. All metal components are subject to normal rust and corrosion.
GENERAL SHALE OUTDOOR LIVING PRODUCT WARRANTY
ANY IMPLIED WARRANTIES ARE HEREBY DISCLAIMED AND ARE EXPRESSLY EXCLUDED.
PART NO. WBX-150
DIFFICULTY NOVICE
APPROX. DIM. 3'W x 2'D x 4'H
P.O. Box 3547 / Johnson City, TN 37602 / 1-800-414-4661 / www.GeneralShale.com
APPROX. WEIGHT 2,485 lbs.

“Stacker 150” Woodbox (WBX-150) Assembly Instructions
P.O. Box 3547 / Johnson City, TN 37602 / 1-800-414-4661 / www.GeneralShale.com
Materials included with your outdoor kit.
Note: Actual components may vary slightly. Some cutting may be required.
NOTE: is unit is designed for outdoor use only. is unit is not designed to be used on
wood decks or under roof enclosures. Locate unit reasonable distance from any combustible
materials. Comply with local building code(s) and burning permits as applicable. Retain these
instructions with unit.
Additional materials required to install your kit.
Concrete or Gravel (for setting base)
Level
Tape Measure
Small Trowel
5 gal. Mixing Bucket
Note: You may also use landscape adhesive (available separately) in place of supplied thin set mix.
2
A-(7) 4"x 8"x 16"Block
B–(12) 4"x 8"x 12"Block
B1–(5) 4"x 8"x 14"Bullnose
B2–(1) 4"x 4 ½"x 14"Bullnose
B3–(1) 4"x 6 ¾"x 14"Bullnose
C1–(1) 4"x 8"x 8"Bullnose
C2–(1) 4"x 8"x 8"Bullnose Corner
C3–(2) 4"x 5"x 8"Bullnose
D–(42) 4"x 8"x 4"Block
E–(16) 4"x 4"x 16"Block
F–(31) 4"x 4"x 12"Block
F2–(2) 4"x 4"x 11 ¼"Block
G–(6) 4"x 4"x 4"Block
H–(1) 4"x 4 ¼"x 8"Block
I–(1) 4"x 6 ¾"x 12"Block
(1) 6"x 8"x 27"Cast Lintel
(1) 4"x 8"x 27"Concrete Lintel
(1) in Set Mix Bag

Step
1Create a level base using Crusher Run Stone to accommodate the overall footprint
of the woodbox kit.
Prepare an area 3'6"wide x 2'6"deep.
Remove sod and vegetation.
Excavate/remove so soil as required to provide level stone surface at a
minimum of 4"deep.
If soil under sod is hard, soil can be leveled out and used as a base material.
If required, use landscape blocks to retain stone base.
If installing optional hearth/knee wall, extend base as required.
(Base Section View)
Reference diagrams for creating a level base.
Undisturbed Ground
Existing Ground Screed Stone Base Level
4"
4"min. Crusher Run Stone
3'6"
2'6"
NOTE: All outdoor living kits can be installed directly on a properly prepared stone base. However,
for best performance and appearance, a concrete pad is recommended.
“Stacker 150” Woodbox (WBX-150) Assembly Instructions
P.O. Box 3547 / Johnson City, TN 37602 / 1-800-414-4661 / www.GeneralShale.com
Woodbox Outline
3'x 2'
(Base Plan View)
FRONT
3'6" x 2'6"
Crusher Run Base
(4" min. thickness)
3

“Stacker 150” Woodbox (WBX-150) Assembly Instructions
P.O. Box 3547 / Johnson City, TN 37602 / 1-800-414-4661 / www.GeneralShale.com
B
B
B
B
B
B
B
B
B
Course 1
(9) B - 4"x 8"x 12"Block
B
B
B
B
B
B
B
B
B
B
Course 2
(6) A - 4"x 8"x 16"Block
A
A
F2
F2
A
A
A
A
(2) F2 - 4"x 4"x 11 ¼"Block
Step
2Build the woodbox (courses 1 and 2).
Assemble the woodbox on a level setting base.
Mix thin set according to manufacturers instructions. Apply thin set to
the inside of block to prevent excess from squeezing out onto the face of
the woodbox.
Apply thin set layer with small trowel to bond courses.
Aer laying the rst course, check to make sure it is level before proceeding.
4

“Stacker 150” Woodbox (WBX-150) Assembly Instructions
P.O. Box 3547 / Johnson City, TN 37602 / 1-800-414-4661 / www.GeneralShale.com
Step
3Build the woodbox (courses 3 and 4).
Apply thin set to the inside of block to prevent excess from squeezing out
onto the face of the woodbox.
Use supplied thin set between all courses and all block.Use supplied thin set between all courses and all block.
Course 3
(1) A - 4"x 8"x 16"Block
(2) B1 - 4"x 8"x 14" Bullnose Block
(1) B2 - 4"x 4 ½"x 14" Bullnose Block
(6) D - 4"x 8"x 4"Block
(2) E - 4"x 4"x 16"Block
(2) F - 4"x 4"x 12" Block
(1) H - 4"x 4 ¼"x 8"Block
F
DFD
F
DD
E E
A H
B1 B2 B1
Course 4
(4) D - 4"x 8"x 4"Block
(2) E - 4"x 4"x 16"Block
(4) F - 4"x 4"x 12"Block
(1) G - 4"x 4"x 4"Block
F
EGE
F
DD
DD
FF
DD
5