3
PANEL VIEW:
LED Indication:
POWER Green on: Power on
INPUT Blue on: HDMI Input connected
OUTPUT1 Blue on: HDMI output 1 connected
OUTPUT2 Blue on: HDMI output 2 connected
OUTPUT3 Blue on: HDMI output 3 connected
OUTPUT4 Blue on: HDMI output 4 connected
Switch Instruction:
• DIP Switch 1~4 OFF: Default as EDID 1080P
• Switch ON 1: Output 1 as EDID source.
• Switch ON 2: Output 2 as EDID source.
• Switch ON 3: Output 3 as EDID source.
• Switch ON 4: Output 4 as EDID source.
• Over 1 DIP switch ON: EDID analysis and re-generate a set of EDID for all screen resolution.
• Example: Output 1,2 are different resolution screen, move the DIP switch 1, 2 at ON position, press
“ EDID COPY” button, then re-generate a new a set of EDID to support both two monitors screen
resolution.
EDID COPY Button Instruction:
Press “EDID COPY” button, start to learning and writing EDID.
Remark: Over 2 port EDID learning, audio will only support two channel audio.
Console Port:
R232 interface connect to PC for rmware updated
DIP Switch for EDID