Genius Traveler 9020BT User manual

English
- 1 -
Hardware Installation
1. Install one AA or AAA battery in the mouse as instructed.
2. Make sure that you have switched on the power switch underneath the mouse.
Mouse Button Assignments
1. Left Button: Provides traditional mouse functions like
click, double click and drag.
2. Magic-Roller: Press the “Magic-Roller” to surf the
Internet and Windows documents.
3. Right Button: Provides traditional mouse click functions.
4. Switch Device Button: Press this button to switch
between PC or tablet device.
Note: Download the programmable driver from our website:
www.geniusnet.com
Warning: (Troubleshooting)
1. Do not use the wireless optical/laser mouse on a desk
which is made of glass or mirror.
2. The connection of the wireless device is factory preset,
so when you plug the USB receiver into any USB port,
the connection between the micro receiver and the mouse will be established
automatically.
3. In case your PC did not install the hardware successfully, remove the micro receiver from
the USB port and go Human Interface Devices under Device Manager to remove the
mouse then plug in the micro receiver to a USB port again.
4. If you feel the mouse does not move smooth asusual, it is possible the battery has lost its
charge so you need to replace it. Remember to put thebattery in the correct direction.

English
- 2 -
FCC :
Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
_ Reorient or relocate the receiving antenna.
_ Increase the separation between the equipment and receiver.

English
- 3 -
_ Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
_ Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions : (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.