Gentex ADVGEN40A4 User manual

Ignition12 VGround
Ignition Power Wire (Black & White)
Constant Power Wire (Black)
Ground
APPLICABLE KITS:
ADVGEN40A4
ADVGEN45A4
ADVGEN45AB5
ADVGEN45A4PW4
ADVGENFL8EXP
ADVGENFL80EXP
ADVGENFL85EXP
For full installation guides call technical support:
1-844-569-4654
9am –9pm (Eastern) Mon –Friday
10am –2pm (Eastern) Sat
or visit
www.VOXXElectronics.com
4280819

1. Adjust compass zone after mirror installation.
a) The zone setting is factory preset to Zone 8. Refer to Compass
Calibration Zone Map to find correct compass zone setting for your
geographical location.
b) To change the zone setting, push and hold the button for
approximately 9 seconds until a number appears in the display.
c) Press button repeatedly until desired compass zone number is
reached.
2. Calibrate compass.
a) Drive to an open, level area, away from large metallic objects or
structures.
b) Hold the button for approximately 12 seconds until “CAL” or "C" text
appears in the display. Release the button to enter the calibration
mode.
c) Drive slowly in up to 3 circles until the “CAL” or "C" text disappears,
and a directional heading is displayed.
The compass is now calibrated.
ONLY FOR MIRRORS WITH COMPASS