George Home GSM101B-20 User manual

尺寸：148X210mm
页码：12页
材质 : 70g书纸
印刷颜色：单色印刷
印刷版面：双面印刷
装钉：骑马钉
警告语：首字母字体高度3.03（12pt)
项目
库
文件名
A
1246
3
5
B
C
D
E
F
G
A
B
C
D
E
F
G
说明书
MJ-BH4001W
16164000A07262
1 1
1:1
会 签
K
HH
田龙飞
2020.6.24
制 图
设 计
校 对
标准化
审 定
日 期
标记
A/修改说明书第10页，11页地址，增加UKCA标志/詹威/2021-07-15
处数 更改文件号 签 字 日 期
重点
校对项
1.结构尺寸
2.材质标注
3.物料编码
4.颜色标注
5.客户型号
6.电压功率
7.认证信息
8.条码数字
9.产品名称
古广君
李小丁
-----
徐明旭
-----
主力智业（深圳）电器实业有限公司
GH-MJ-KM6001W
（ GSM101B-20）-0501
认 证 符官文

IMPORTANT: RETAIN FOR FUTURE REFERENCE
GSM101B-20
George Home stand mixer
User Guide 220-240V~50-60Hz,600W

1
WARNINGS:
THIS PRODUCT WAS DESIGNED AND MANUFACTURED TO
MEET STRICT QUALITY AND SAFETY STANDARDS. THERE ARE,
HOWEVER, SOME OPERATIONAL PRECAUTIONS YOU SHOULD
BE AWARE OF.
1. Read all warnings & instructions in this manual to ensure you
get the best out of your product.
2.
stand mixer, cord, or plug in water or liquid. Do not use with
wet hands.
3. Keep away from harsh or abrasive cleaning agents or
solvents.
4. Remove all protective wrapping prior to use.
5. Avoid outdoor and commercial use. This appliance is for
household use only.
6. Do not use if the appliance, cord or plug is damaged.
7. If the supply cord is damaged, it must be replaced by the
in order to avoid a hazard.
8.
9.
the voltage shown on the appliance corresponds with the
voltage in your home. If it doesn’t, contact your local store.
10. The cord shouldn’t hang over the edge of a table or counter,
or touch a hot surface.
11. Keep away from hot gas and electrical burners.
12. Do not use attachments not recommended by the
manufacturer.
13. The appliance is not intended to be operated by means of an
About this guide
We’re here to help you get the most from your stand mixer,
so please keep hold of this manual for future use.

2
external timer or separate remote-control system. Don’t use
the stand mixer for anything other than its intended use.
14. Please don’t dismantle. If a fault occurs have the stand mixer
15. Do not continuously operate for more than 7 minutes, at
any speed setting, at a time as this can overheat the motor.
Always allow the motor to cool to room temperature before
continuing to use.
16. Always disconnect the appliance from the supply before
assembling, disassembling, changing accessories or cleaning.
17.
parts. Only use a scraper when the appliance is not in use.
18. Remove beater, dough hook or whisk from the stand mixer
before washing them.
19. Do not use the appliance to mix really hard ingredients.
20. Avoid adding boiling hot liquids to mixtures.
21. Do not leave the stand mixer unattended when in use.
22. This appliance shall not be used by children. Keep the
appliance and its cord out of reach of children.
23. This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and if they
understand the hazards involved.
24. Children shall not play with the appliance.
25. Switch off the appliance and disconnect from supply
before changing accessories or approaching parts that
move in use.
26. Environmental information: If at anytime in the future you
should need to dispose of this product, please note that, in
the UK, waste electrical products/batteries should not be
disposed of with household waste.

3
You should have
Mixer, bowl, whisk, beater,
splashguard & dough hook
How to…
…recognise the parts of your stand mixer
(4.0L)
Accessory connector
Tilt release button
Speed adjuster dial
plashguard
Bowl Dough hook Whisk Beater
S

4
How to…
…assemble/disassemble the attachments on your
stand mixer
Please note
When assembling ensure the mixer isn’t plugged into the mains and the speed adjuster
attachments in warm, soapy water and dry thoroughly.
Select the desired attachments, depending on your mixing task:
Whisk
for whisking
cream, egg
whites, light
batters.
Dough hook
for kneading
dough
and heavy
mixtures.
Beater
for mixing/
folding
frostings,
mashed
potato, cake
mix, pastry.
1. ehttlitotnottubesaelertlitehtsserP
mixer head back (1). Place the bowl on
the mixer stand and rotate the bowl in
the direction of the ‘lock’ padlock until
it locks into place .
Place bowl in bowl base and turn
clockwise until bowl locks into
place.
dial is set to ‘0’. Before using for the first time, we recommend you wash the bowl and

5
3.
2.
Insert attachment onto output
shaft and press upward as far
as possible. Turn the attachment
hooking attachment over
pin on shaft.
Press the tilt release button
to tilt the mixer head up.
Press the tilt release button and push the mixer head
down until it locks into place. Slide in the splashguard
and make sure it is well seated on the bowl. The stand
mixer is now ready to use.
Place whisk, beater or dough hook into the accessory
connector. Push up and rotate as far as it will turn, and
then release the accessory so it locks over the pin on the
connector. To remove the accessory, push up and turn
the opposite way to unlock.

6
How to…
…use your stand mixer
2. Press the tilt release button and lift the mixer head. Add the bulk of your
ingredients to the bowl. Do not exceed 2/3 of the full capacity. Press the tilt
release button again and push the mixer head down until it locks into place.
1. Plug the mixer into the power socket and switch
on. Ensure the speed adjuster dial is set to ‘0’.
Ensure the stand mixer is on a flat, stable surface
and away from the edge. The suction feet should
help stick the stand to the surface.
3. To turn the mixer on, turn the speed adjuster
dial to the desired speed (between 1 and 6).
1 being the slowest and 6 the highest. The mixer starts with a low
through to a
fast setting, more for use with the whisk attachment.
NOTE: Improper speed may cause abnormal noise
and shaking.
You should always start the stand mixer at the lowest
speed relevant for the type of attachment and
gradually work up to the faster speeds. Remember
to never continuously use the stand mixer for more
than 7 minutes at a time and to allow to cool to
room temperature before continuing to use.
7
5. When you’ve finished using the mixer, simply
turn it off by turning the speed adjuster dial
to the ‘0’ position.
setting, ideal for use with the dough hook attachment,

7
As a guide for mixing using the attachments, please refer to the table below.
7.
6. Turn off at the mains socket and unplug.
Name Purpose
• For making bread, pizza bases and dough mixes.
• Suggested processing speed: 2
Hook
• For whipping egg whites, cream, meringues, mousses and soufflés
• Suggested processing speed: 6
Whisk
• For mixing cake batters, cookie dough, pie and pastry recipes, mashing
potatoes, pasta dough, gluten free bread, and softening cold butter.
• Suggested processing speed: 1-4
• 3 eggs, 150g butter, 150g castor sugar, 150g flour, 3g baking powder.
• Basic dough recipe: 500g flour, 50g olive oil, 1 teaspoon salt, 1
teaspoon sugar, 7g yeast, 260g warm water
Beater
Press the tilt release button and lift the
stand mixer head. To remove the
attachment, push the attachment up
and turn clockwise to release it.

8
How to…
…change the fuse
1. Only use a 10 amp fuse.
2. To change the fuse, place a screwdriver into the
recess of the plug cover and pull the fuse holder
upward until it’s free.
3. Slide the fuse out and pop in the replacement.
4. Slot the fuse holder back into the recess and push
down until it locks into place.
How to…
…clean your stand mixer
Make sure the stand mixer is switched off and disconnected from the power.
1. Wipe over the outside surfaces with a damp cloth and wipe any excess food particles
from the power cord (never immerse the mixer or power cord in water or liquid).
2. Wash the bowl, splashguard, whisk, beater and dough hook in warm soapy water and
dry thoroughly.
The bowl and the accessories are dishwasher safe for easy clean up.
3. Ensure all items are completely dry before storing the stand mixer in a cool, dry place.