German pool GIC-BS26B User manual

使用說明書
在使用之前請詳細閱讀「使用說明書」及「保用條例」，並妥善保管。
Please read these instructions and warranty information carefully
before use and keep them handy for future reference.
GIC-BS26B
BUILT-IN INDUCTION COOKER
嵌入式電磁爐

P.2
目錄 Table of Contents
安裝說明 Installation Instructions 03
產品結構 Product Structure 04
操作說明 Operating Instructions 05
鍋具 Cookware 06
安全注意事項 Safety Cautions 07
保養與清潔 Care & Maintenance 08
常見故障及處理 Troubleshooting09
技術規格 Technical Specications 10
保用條款 Warranty Terms & Conditions11

P.3
Exhaust
Successfully
Exhaust
Unsuccessfully
O.K
WRONG
Kitchen Worktop
錯誤
Kitchen Worktop
正確
Induction Cooker
電磁爐
Induction Cooker
順利排氣
櫃檯檯面
無法排氣
電磁爐
櫃檯檯面
安裝說明 Installation Instructions
安裝前注意 Notice
﹣嵌入式電磁爐周圍不應有任何障礙物阻擋機身，以免影響電磁爐的散熱效能
There should not be any obstacles surrounding the unit
﹣請確保電源插頭設在方便接插的地方，並必須接上地線
Make sure power plug is accessible after installation. Power outlet must be earthed
1. 安裝時，注意機身底部以下必須預留
 不少於250mm高的空間排風。
For ventilation purposes, there should be
no less than 250 mm high empty space
under the unit body.
2. 機身底部進出風口不能設在封閉的空間裡，
 必須保持與不同空間的空氣連接，並儘量與
 房間裡的空氣保持一定程度的連接。
Air vent under the unit must be well circulated.
Circulation between space under the unit and room
atmosphere should be present.
250 mm
1. 依據參考開孔尺寸 264mm(W) x 379mm(D)，
在廚櫃檯面開孔。
According to cutout dimensions
264mm(W) x 379mm(D), make a cutout
hole on the cabinet/counter top.
2. 將隨機的耐油橡膠貼於玻璃支架底部的黏
 貼處，然後將機身嵌入櫃中。
Attach the supplied rubber tape to the bottom part
of the unit body, and then place unit through the
cutout hole.
3. 插上電源，安裝完畢。
Connect power and cooker is ready to use.
注意：安裝時必須確保後排氣口高於
檯面，使之能正常出風（如上圖所示）
Notes: When the induction cooker is installed,
the exhaust outlet must be put ONTO the
kitchen work-top, so that it can exhaust
successfully. Please refer to the above pictures.
安裝程序 Procedures

P.4
產品結構 Product Structure
排氣口
Venting Outlet
吸氣口
Air Inlet
電源插頭
Power Cord & Power Plug
微晶玻璃面板
Cook-Top Panel
操作面板
Control Panel
線控器
Corded Control
控制面板 Control Panel
外型 Main Body
定時顯示
Timer
火力段數
Power Level Setting
“面板餘熱”指示燈
“Hot” Indicator
“電源”指示燈
“Power On” Indicator
“定時/取消”鍵
Timer/Cancel
“+/–”控制鍵
“+/–” (Adjustment)
“電源開關”鍵
“ON/OFF” Key
“鎖定/解鎖”鍵
“Lock/Unlock” Key
面板餘熱
定時 減加電源開關 鎖定

P.5
操作說明 Operating Instructions
按鍵說明
“電源開關”鍵键
打開總電源開關後或於休眠狀態下，按此鍵以進入待機
狀態（電源指示燈會亮起）；再按此鍵一次可轉回休眠
狀態。

“定時/取消”鍵
於“加熱狀態”下，按此鍵切換至“定時狀態”，顯示
燈會顯示“30”並開始閃動，可按“+/”控制鍵調校定
時設定(1分鐘至6小時：1至99分鐘時定時顯示器顯示
“01-99”，2至6小時時定時顯示器顯示“2h-6h”），
完成後，定時顯示器會停止閃爍而轉為常亮。再按此
鍵可取消定時設定。


 “+/”控制鍵
於“待機狀態”下，按此兩鍵可使電磁爐進入加熱狀態。
於“加熱狀態”下，按此兩鍵可設定火力(功率)大小。
於“定時狀態”下，按此兩鍵可設定預約關機時間。


“鎖定/解鎖”鍵
按此鍵可使機器進入鎖定狀態，此時，除按“電源開關”
鍵以外，其他任何按鍵操作無效；在鎖定狀態下，長按
此鍵3秒可使機器進入解鎖狀態，此時，所有按鍵操作
有效。
1. 將電磁爐插頭插入插座，打開總電源開關，電磁爐發
 出“嗶”的一聲，表示電磁爐進入“休眠狀態”。
2. 將鍋具放置於陶瓷玻璃板中央，按“電源開關”
 鍵，電源指示燈長亮，再按或鍵，電磁爐便
 進入加熱狀態（預設火力：第3段）。


3. 按或增減火力段數。
 注：若沒有放置鍋具或鍋具不合適，電磁爐不會進行
 加熱，並會發出警告。
 單個爐頭功率調節表（兩爐頭完全相同)
4. 在“加熱狀態”下，按“定時/取消”鍵以進入
“定時狀態”，按或鍵設定1分鐘至6小時關機
 時間(1至99分鐘時定時顯示器顯示“01-99”，2至6
 小時時定時顯示器顯示“2h-6h”。
Control Buttons Functions
“POWER ON / OFF” Key
Turn on the Main ON/OFF Switch or under“Sleeping” mode),
press to enter “Heating” mode (power inicator will be on).
Press again to switch off operation and return to “Sleeping”.
“TIMER / CANCEL” Key
Press this key to set timer. When the digits “30” are ashing, press
“+” or “–” key to adjust timer settings between 1 minutes to 6 hours
(the timer indicator will display “01-99” when the timer setup is from
1 to 99 minutes and the timer indicator will display “2h-6h” when the
timer setup is from 2 to 6 hours). Timer will start counting down when
time display stops ashing. To cancel timer, press this key again.
“+/–” Adjustment Keys
Under “Sleeping” mode, press to enter “Heating mode”Under
“Timer Mode” (i.e. when “Timer” Indicator lights up), press to
adjust timer.
Under “Heating” mode, press to set power level.
“LOCK/UNLOCK” Key
Press this key to lock all settings at “Heating” mode or
“Timer” mode. Under “Lock” status, induction cooker would
not respond to any key press. Press this key for 3 seconds to
unlock “Lock” status.
1. Connect power plug, and then turn on the Main ON/OFF
switch. A “beep” sound is heard, indicating that cooker is
in “Sleeping” mode.
2. Place cookware in the centre of cooking hob. Press
“POWER” key and power indicator will light up, then press
or indicating that cooker is in “Heating” mode.
(Default value: Level 3)
3. Press or to adjust power level.
Note: if there is no cookware or cookware not appropriate,
cooker will not start operation and a buzzing sound is heard.
Power table of single hob (One is as same as the another)
4. In “Heating” mode, press “ TIMER/CANCEL” key to enter
“Timer” mode. Press or to set shutdown time ranging
from 1 minutes to 6 hours ( the timer indicator will display
“01-99” when the timer setup is from 1 to 99 minutes and
the timer indicator will display “2h-6h” when the timer setup
is from 2 to 6 hours).
注意：當鍋具不適用或沒有放置好時，數碼管會顯示
“E0”且閃動以作警示，但電磁爐並不會進行加熱。
Note: if no cookware or cookware is not appropriate,
the digital display will show “E0” and start to ash.
Note: if no cookware or cookware is not appropriate,
the digital display will show “E0” and start to ash.
注意：當鍋具不適用或沒有放置好時，數碼管會顯示
“E0”且閃動以作警示，但電磁爐並不會進行加熱。
火力段數
Power Level
1
(低 MIN) 2345678910 (高 MAX)
功率 Power 300W 800W 1100W 1200W 1300W 1400W 1500W 1600W 1700W 2400W