GERMANICA GFDM-30R User manual

INSTRUCTION MANUAL
Please read this manual carefully before using, and keep it for future reference.
FROZEN DRINK
MAKER
GFDM-30R

CONTENTS
General Safety 4
Before first use 6
Product Overview 7
Operation 8
How to use the Frozen Drink Maker 8
Cleaning & Maintenance 10
Troubleshooting 11
Specification Last Page
Customer Support Last Page

4
GENERAL SAFETY
Read this manual thoroughly before you start using the product.
Store this manual, the completed warranty card, your receipt and the product
packaging.
The safety precautions instructions reduces the risk of fire, electric shock and
injury when correctly complied to.
Please follow all instructions and take notice of all warnings.
• Do not expose this product to rain or moisture.
• Do not temper or change or modify the product in any way.
• Only use Accessories outlined and recommended by the manufacturer.
• Please do not expose the product to splashing or water contact
IMPORTANT INFORMATION
• The apparatus shall not be exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed on the product. Dry location
use only.
• No naked flame source, such as candles, should be placed on the product.
• This appliance is not to be used by persons (including children) with reduced
physical, sensor or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction.
Children being supervised not to play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard
• Do not use if blade is broken, cracked or loose. Do not leave appliance
unattended while it is operating its service agent or similarly qualified persons
in order to avoid a hazard.
• Never place fingers or utensils into the feed or discharge areas to reduce the
risk of service injury to persons or damage to the shaver.
Inside the Top compartment where you insert the Ice, The blade is
sharp. Use extreme caution during assembly, while
operating, disassembly and cleaning.

5
GENERAL SAFETY (CONT.)
• If you notice any unusual odors or smoke around the unit, immediately
turn o the device and contact the service center. Failure to do
so may result in fire or electric shock.
• Please beware that Dust could accumulate over time on the unit and cause it
to generate heat and or deteriorate insulation, which in turn may result in an
electrical fire.
• To maintain the product do not use any chemical or cleaning agent or wet
cloth, please only ensure to utilize a dry cloth to wipe it down from marks or
dust and only after unplugging the product from the power socket.
• Please ensure to contact our call center for any repair or service required for
the products.
Please make sure upon positioning this product, the place is:
• Not wet or damp and Well ventilated
• Away from direct sunlight or heaters.
• Protected from excessive dust or grease.
• Do not place the Product near heat sources such as radiators, stoves or other
audio visual equipment that produce heat.
• Do not place small metallic objects on top of the unit.
• Do not use or store flammable or combustible materials near the unit. Doing so
may result in fire or explosion. Do not place any naked flame sources, such as lit
candles, cigarettes or incense sticks on top of the product.
This appliance is intended to be used in household and similar applications as:
-sta kitchen areas in shops, oces and other working environments
-farm houses
-by clients in hotels, motels and other residential type environments
-bed and breakfast type environments
• Switch o the appliance and disconnect from supply before changing
accessories or approaching that move in use.
• Warn of potential injury from misuse.

6
GENERAL SAFETY (CONT.)
Before first use
• Unpack the product and accessories and ensure all parts of the product
are undamaged and in good working order.
• Plastic wrapping can be a suocation hazard for babies and young
children, so ensure all packaging materials are out of their reach and
disposed of safely.
• Unwind the power cord to its full length and inspect it for damage
before each use. Do not use the product if it or its cord has been damaged
or is not working properly. In case of damage, contact our after sales sup
port line for advice on examination, repair or return of the damaged product.
• Ensure the product is not exposed to direct sunlight or placed near a
heater or other heat source.
Please check all packaging material carefully before discarding.
Many accessory parts are contained within the packaging material.
Hand-wash the transparent cup, stirring rod, auger drum, securng nut and lid in
warm, soapy water. Rinse and dry thoroughly.
Be careful when handing the sharp cutting blades, emptying the bowl and
during cleaning.
Be careful if hot liquid is poured into the food processor or blender as it can be
ejected out of the appliance due to a sudden steaming.

7
PRODUCT OVERVIEW

8
OPERATION
USING YOUR FROZEN DRINK MAKER
1. Line up the four outside tabs of the mainbody assembly with the
matching grooves on the auger drum,place the auger drum inside
the main body, Lock the auger in place with the securing nut by
turning nut clockwise. Push gently in place to secure.
CAUTION: The mainbody contains a sharp shaving blade, handle
with care.
2. Place the stirring rod into the transparent cup (Note: the bottom
hole of the stirring rod must insert into the middle post of the
transparent cup); Then put the transparent cup on the main body
bottom and rotate clockwise into place.
3. Add ice cubes to auger.
4. Plug the frozen drink maker into a 220-240V, AC electric outlet only.
5. Place the lid on top of the main body, aligning the tabs. Turn the
lid counterclockwise until the lid tab engages the interlock switch.
The motor will start and the ice will begin shaving.
6. To stop shaving ice, turn the lid clockwise to disengage the
motor switch.
7. Unplug from power supply immediately after use.
Note: There will always be a small amount of ice remaining in the
auger after shaving. Discard the remaining ice.
8. Counterclockwise and remove the transparent cup, then you can
enjoy the shaved smoothie.

9
OPERATION (Cont.)
CAUTION: Do not run frozen drink maker continuously for longer than 5
minutes as overheating may occur. Allow motor to cool down before
repeat usage.
• A small amount of smoke and/or odor may occur upon use due to
the release of manufacturing oils- this is normal.
• Some minor expansion/contraction sounds may occur during
use - this is normal.
• Adjusting knob can adjust the size of shaved ice;
• Beforce shaved ice cube,you can add the right amount of drink to
the transparent cup (This approach is recommended); Under
normal circumstances, process a rotary cylinder of square ice (about
250 grams,size 2*2*2cm), add about 170 grams of drink; two rotary
cylinder of ice about add 420 grams of drink;
• In either case, processed crushed ice must not exceed the maximum
scale of the transparent cup.

10
CLEANING & MAINTENANCE
1. Always unplug appliance before cleaning.
2. Hand wash parts in warm, soapy water. Rinse and dry thoroughly.
CAUTION: Be extremely careful of shaving blade in main body as
blade is very sharp.
3. Clean exterior of the appliance with a damp, soft cloth and wipe dry.
Note: Do not immerse motor housing in water or other liquid.
NEVER ATTEMPT TO SHARPEN SHAVING BLADE AS INJURY
MAY OCCUR.
This appliance has no user serviceable parts.
HELPFUL HINTS
• Be sure you have an adequate supply of ice cubes.
• If your motor is laboring or if you get poor shaving results, soften
your ice cubes. This can be done by letting your ice sit at room
temperature for a few minutes, or running briefly under cool
tap water.
• DO NOT overfill the auger; the cover should sit flush without forcing.
• Cube shaped ice performs better than the half-moon shaped ice
from ice makers or round cubes from store-bought bagged ice.

11
TROUBLESHOOTING
Troubleshooting
If your products stops working, contact our call centre
at [e-mail].
Do not attempt to open and repair the unit yourself.

SPECIFICATIONS
Power Supply 220-240V ~ 50/60Hz, 30W
CUSTOMER HELPLINE:
[e-mail]
DISTRIBUTED BY:
Ayonz Pty Ltd