Ghent FPM1M164 Series User manual

(1)
Whiteboard
(1)
Vinyl Board
(2)
Leg
(4)
Glide
(1)
Cross Brace
(6)
End cap
(2)
Bracket
(2)
Acorn nut
10-24
(2)
10-24 x 1"
(8)
10-24 x 1-1/2"
(4)
10-32 x 1-1/4"
10-24 x 1" Screw
Acorn nut
A
DETAIL A
SCALE 1 : 5
Step 2: Install the glides and end caps.
Fixed Partition (FPM1M1)
Instruction Sheet
Step 1: Remove and unpack carton contents.
www.ghent.com/install - Lebanon, OH 800-543-0550 IS-FPM1M1 (3/20)
Step 3: Install bracket onto legs using 10-32 x 1-1/4" screws, thread screws into bracket. Do not tighten.
Step 4: Using a table (6) feet or more in length, organize the legs and cross brace as shown below,
hand tighten 10-24 x 1" screws with acorn nuts.
(PAGE 1 OF 2)

10-24 x 1-1/2" Screws
Note rivets
at top on
whiteboard
Note rivets
at bottom
on vinyl board
Step 5: Install the vinyl board and the whiteboard as shown below.
4a. Align both boards flush with the cross brace. Check remaining screw holes to verify that the
boards are oriented properly.
4b. Use 10-24 x 1-1/2" screws to mount both panels onto the legs hand tight.
4c. Tighten all screws.
4d. Carefully remove the Fixed Partition unit from the table by carrying the legs. Then move to
the intended location.
www.ghent.com/install - Lebanon, OH 800-543-0550 IS-FPM1M1(3/20)
(PAGE 2 OF 2)