Giant TURBO LASER User manual

Turbo Nozzle
04/21 23000.INDD
Model # Nozzle Size Repair Kits*
23000-020 2.0 09620-020
23000-025 2.5 09620-025
23000-030 3.0 09620-030
23000-035 3.5 09620-035
23000-040 4.0 09620-040
23000-045 4.5 09620-045
23000-050 5.0 09620-050
23000-055 5.5 09620-055
23000-060 6.0 09620-060
*Repair kits include items 2-12
MAINTENANCE NOTICE:
If turbo will not spin, take unit apart and clean the nozzle. If turbo still will not spin, have an authorized distributor repair nozzle.
Operating Conditions
Maximum Flow: 22.0 GPM (83 L/min)
Maximum Pressure: 3600 PSI (248 bar)
Maximum Temperature: 195 °F (90 °C)
Spray: 20°
Weight: 1.4 lbs. (0.64 g)
Connection: 1/4" FBSP+
+To convert from BSP to NPT threads order part numbers 06581
(1/4" MBSP x 1/4" FNPT) or 06581M (1/4" MBSPx1/4" MNPT)
*WARNING *
HIGH PRESSURE
DO NOT POINT
AT INDIVIDUAL
MAY CAUSE
SERIOUS INJURY!
Giant Industries, Inc.
900 N. Westwood Ave.
Toledo, Ohio 43607
PHONE: [phone]
FAX: [phone]
www.giantpumps.com
©Copyright 2021 Giant Industries, Inc.
Series
23000
WARNING: This product might contain a chemical known
to the State of California to cause cancer, and birth
defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov

TURBO LASER REPAIR INSTRUCTIONS
1. Using a 24 mm boxed end wrench and a 24 mm socket unscrew the drive plug
(13) from the discharge casing (1).
2. Remove rotor assembly (4-11) and replace with items in kit.
3. Using a 5/16" wooden dowel rod press out ceramic seat and o-ring (2-3) from the
top side of discharge casing (1). Replace with new ceramic seat and o-ring.
4. Inspect o-ring (12) for damage and replace if necessary.
5. Insert rotor assembly (4-11) into the bell cover (1) and reassemble & tighten the
drive plug (13) and discharge casing (1).
NOTE: Gently shake nozzle to make sure the rotor assembly can freely move.