Gigabyte GN-BT01H User manual

1
English
Volume Up
Preparing The Headset
GN-BT01H Bluetooth headset can be connected to any device with
Bluetooth wireless technology that supports handsfree profile.
Microphone
Volume Down
Call Handlin
g
Button
Mode Button
Indicator Li
g
ht
Speaker
Front
Back

2
English
Getting Started
Before you start to use this headset you should
♦ Charge the headset.
♦ Pair the headset with a device.
 Charging
First Time Charging : GN-BT01H must be charged fully before you
use headset for the first time.
During Charging : Indicator light shows steady RED light.
Fully Charged :Indicator light goes off.
The headset can be charged either using a power adapter or a USB
cable charging from PC.
 Turn on the Headset
Press “Call Handling Button” for 2 seconds and you will see flashing
Blue Indicator light then release the button.
USB
Connector
To
p
Dongle Mode
Indicator

3
English
 Turn off the Headset
Press “Call Handling Button” for 5 seconds and the indicator flashing
blue and goes off and then release the button.
 Pairing the Headset
Before you use the headset, you must pair the headset with a device.
1. Follow mobile phone user guide on “how to turn on Bluetooth
and add a Bluetooth device” to mobile phone.
2. Set into paiting mode. Press “Volume Up” and “Call Handling
Button” buttons together for 3 secods until the indicator light
flash blue and green. The headset is now ready for pairing.
3. Continue follow the instruction of the mobile phone’s user manual
to add the headset into list.
4. The passkey of the headset is 0000.
 Using the Headset
Answer a call : Hear ring tone of the headset, press “Call Handling
Button”. To end the call, press “Call Handling Button”
Adjust Speaker volume : Press “Volume Up” for increase volume.
Press “Volume Down” button for decrease volume.
Making a call :
1. Dial number on mobile phone keypad.
2. Press “Call Handling Button”, say your voice dial as normal after
beep.
(Refer to the mobile phone’s user menu for setting up voice dail
function.)
Reject a phone call : Press mode button for 3 seconds while you hear
the ring tone.
Redial a phone call : Press mode button for 3 seconds.

4
English
 Dongle Mode Setting
The headset can be configured as a Bluetooth USB dongle. The USB
dongle can be used to transfer data between mobile phone and PC.
Set To Dongle Mode
Press “Mode Button” and “Call Handling Button” together for 3
seconds. Dongle Mode indicator turns on as green.
Set To Headset Mode
Unplug USB Cable; the headset will automatically switch off.
Headset goes to headset mode when you turn on headset.