Gigabyte AORUS FO48U User manual

TACTICAL
GAMING MONITOR
USER GUIDE

- 2 -
Monitor User’s Manual
Copyright
© 2021 GIGA-BYTE TECHNOLOGY CO., LTD. All rights reserved.
The trademarks mentioned in this manual are legally registered to their
respective owners.
Disclaimer
Information in this manual is protected by copyright laws and is the
property of GIGABYTE.
Changes to the specications and features in this manual may be made
by GIGABYTE without prior notice.
No part of this manual may be reproduced, copied, translated,
transmitted, or published in any form or by any means without
GIGABYTE’s prior written permission.
• In order to assist in the use of this monitor, carefully read the User
Guide.
• For more information, check on our website at:
https://www.gigabyte.com

- 3 -
Monitor User’s Manual
Safety Precautions
Read through the following Safety Precautions before using the monitor.
• Only use the accessories that are provided with the monitor or that
which are recommended by the manufacturer.
• Keep the plastic packaging bag for the product in a place that
cannot be reached by children.
• Before connecting the monitor to the power outlet, make sure that
the voltage rating of the power cable is compatible with the power
specication in the country where you are located.
• The power cord plug must be connected to a properly wired and
grounded power outlet.
• Do not touch the plug with wet hands, otherwise easily cause
electric shock.
• Place the monitor in a stable and well-ventilated place.
• Do not place the monitor near any heat sources such as electric
radiators or direct sunlight.
• The holes or openings on the monitor are for ventilation. Do not
cover or block the ventilation holes with any objects.
• Do not use the monitor near water, drinks, or all types of liquids.
Failure to do so may result in electric shock or damage to the
monitor.
• Make sure to unplug the monitor from the power outlet before
cleaning.
• As the screen surface is easy to be scratched, avoid touching the
surface with any hard or sharp object.
• Use a soft lint-free cloth instead of a tissue to wipe the screen. You
may use a glass cleaner to clean the monitor if required. However,
never spray the cleaner directly onto the screen.
• Disconnect the power cable if the monitor is not being used for a
long period of time.
• Do not attempt to disassemble or repair the monitor yourself.
• The Monitor uses low blue light panel and compliance with TÜV
Rheinland Low Blue Light Hardware Solution at factory reset/default
setting mode (Brightness 40%, Contrast: 50%, CCT: Normal, Preset
mode: Standard).

- 4 -
Monitor User’s Manual
Stability Hazard Precautions
The product may fall, causing serious personal injury or death. To
prevent injury, this product must be securely attached to the oor/wall in
accordance with the installation instructions.
Many injuries, particularly to children, can be avoided by taking simple
precautions such as:
• ALWAYS use stands or installation methods recommended by the
manufacturer of the product set.
• ALWAYS use furniture that can safely support the product.
• ALWAYS ensure the product is not overhanging the edge of the
supporting furniture.
• ALWAYS educate children about the dangers of climbing on furniture
to reach the product or its controls.
• ALWAYS route cords and cables connected to your product so they
cannot be tripped over, pulled or grabbed.
• NEVER place a product in an unstable location.
• NEVER place the product on tall furniture (for example, cupboards or
bookcases) without
• anchoring both the furniture and the product to a suitable support.
• NEVER place the product on cloth or other materials that may be
located between the product and supporting furniture.
• NEVER place items that might tempt children to climb, such as toys
and remote controls, on the top of the product or furniture on which
the product is placed.
• If the existing product is going to be retained and relocated, the
same considerations as above should be applied.
• To prevent personal injury or damage to the product caused by
tipping over due to earthquakes or other shocks, make sure to install
the product in a stable location and take measures to prevent falling.

- 5 -
Monitor User’s Manual
CONTENTS
Safety Precautions............................................................................................................3
Stability Hazard Precautions.........................................................................................4
Introduction .................................................................................................................................6
Unpacking...........................................................................................................................6
Package Contents.............................................................................................................9
Product Overview..........................................................................................................10
Getting Started.........................................................................................................................13
Installing the Monitor Base ........................................................................................13
Inserting the Batteries into the Remote Control................................................ 15
Installing a Wall-Mount Bracket (Optional) ..........................................................16
Making Connections ....................................................................................................18
Using the Device......................................................................................................................19
Turning the Power On/O..........................................................................................19
User Comfort Recommendations............................................................................20
ASS (AORUS Smart System) of Image Sticking Prevention.............................21
Selecting the Input Source.........................................................................................23
Operations .................................................................................................................................24
Quick Menu......................................................................................................................24
Congure the Device Settings..................................................................................29
Appendices................................................................................................................................40
Specications..................................................................................................................40
Supported Timing List..................................................................................................41
Troubleshooting............................................................................................................. 42
Basic Care..........................................................................................................................43
Notes on USB Charging...............................................................................................43
GIGABYTE Service Information.................................................................................43
Safety Information ..................................................................................................................44
Regulatory Notices........................................................................................................44

- 6 -
Monitor User’s Manual
INTRODUCTION
Unpacking
1. Open the top cover of the upper box.
2. Remove the items from the upper EPS foam.

- 7 -
Monitor User’s Manual
3. Remove the locks securing the upper box to the lower box.
4. Firmly hold both sides of the upper box and lift to remove it from the
lower box.

- 8 -
Monitor User’s Manual
5. Remove the upper and sides EPS foams.
6. Carefully remove the monitor from the lower box.
Important: To protect the screen, DO NOT remove the plastic bag around
the monitor until you place the monitor on a table. Refer to page 14.

- 9 -
Monitor User’s Manual
Note: We highly recommended to use at least two people to move the
monitor.
Package Contents
The following items come with your packaging box. If any of them is
missing, please contact your local dealer.
Monitor Monitor Bases (x2) Remote Control
Power Cable HDMI Cable USB Cable
Multilingual
Installation
Guide
AORUS FO48U
Warranty Card
DP Cable Quick Start Guide Warranty Card
Note: Please keep the packaging box and packing materials for future
transportation of the monitor.

- 10 -
Monitor User’s Manual
Product Overview
Front View
1
2
1Power LED 2Control button

- 11 -
Monitor User’s Manual
Rear View
USB 3.0
HDMI
-2 HDMI-1
DP TYPE-C
2 3 5 6 7 81
9
4
1AC IN jack
2Line-Out port
3Headphone jack
4HDMI ports (x2)
5DisplayPort
6USB Type-C port
7USB upstream port
8USB 3.0 ports (x2)
9Kensington lock
Note:
HDMI, the HDMI logo and High-Denition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing LLC.

- 12 -
Monitor User’s Manual
Remote Control
1 2
5
8
7
9
6
4
3
1Power button
2Input button
3Enter button
4Navigation buttons
(up/down/left/right)
5Picture Mode button
6Mute button
7Audio Mode button
8Volume Up button
9Volume Down button

- 13 -
Monitor User’s Manual
GETTING STARTED
Installing the Monitor Base
1. Place the monitor on a table, with the screen facing down.
Note: We recommend that you cover the table surface with soft cloth to
prevent damage to the monitor.
Important: To protect the screen, DO NOT remove the plastic bag around
the monitor until you place the monitor on a table.
2. Align and install the monitor bases into the mounting slots on the
bottom of the monitor.
3. Secure the monitor bases with the four screws.

- 14 -
Monitor User’s Manual
4. Lift the monitor to an upright position and place it on a table.
Note: We highly recommended to use at least two people to lift the monitor.
5. Remove the plastic bag around the monitor.
Removing the plastic bag

- 15 -
Monitor User’s Manual
Inserting the Batteries into the Remote Control
1. Open the battery cover.
2. Insert two AAA batteries into the battery compartment. Ensure that
the batteries are inserted with the correct polarity.
AAA
AAA
3. Replace the battery cover.

- 16 -
Monitor User’s Manual
Installing a Wall-Mount Bracket (Optional)
Use only the 300 x 300 mm wall mount kit recommended by the
manufacturer.
1. Place the monitor on a table, with the screen facing down.
Note: We recommend that you cover the table surface with soft cloth to
prevent damage to the monitor.
2. Remove the four screws securing the monitor bases.
3. Remove the monitor bases.

- 17 -
Monitor User’s Manual
4. Attach the mounting bracket to the mounting holes at the rear of
the monitor. Then use the screws to secure the bracket in place.
300 mm
300 mm
Note: To mount the monitor on the wall, refer to the installation guide that is
included in the wall-mount bracket kit. VESA mounting screw size: M6 x 16mm
minimum.

- 18 -
Monitor User’s Manual
Making Connections
USB 3.0
HDMI
-2 HDMI-1
DP TYPE-C
25 7 8 1 3 6
4
1Power cable
2Audio cable
3Headphone cable
4HDMI cable
5DisplayPort cable
6USB Type-C cable
7USB (A-Male to B-Male) cable
8USB cable

- 19 -
Monitor User’s Manual
USING THE DEVICE
Turning the Power On/O
Power On
1. Connect one end of the power cable to the AC IN jack at the rear of
the monitor.
2. Connect other end of the the power cable to a power outlet.
3. Press the Control button to turn on the monitor. The Power LED will
light in white, indicating the monitor is ready to use.
Note:
• You can also use the button on the remote control to turn on the
monitor.
• If the Power LED remains o after you turn on the monitor, please check the
LED Indicator setting in the Settings menu. Refer to page 37.
Power O
Press the Control button for 2 seconds to turn o the monitor.
Note:
• When the Main menu appears on the screen, you can also turn o the
monitor by moving the Control button down ( ). Refer to page 26.
• You can also use the button on the remote control to turn o the
monitor.

- 20 -
Monitor User’s Manual
User Comfort Recommendations
The following are some tips for comfortable viewing of your monitor:
• Optimal viewing distances for monitors range from approximately
152cm to 244 cm (5 feet to 8 feet).
• A general guideline is to position the monitor such that the top
of the screen is at or slightly below your eye-height when you are
comfortably seated.
• Use adequate lighting for the type of work you are performing.
• Take regular and frequent breaks (at least for 10 minutes) every 30
minutes.
• Be sure to periodically look away from your monitor screen and focus
on a far object for at least 20 seconds during the breaks.
• Eye exercise can help reduce eye strain. Repeat these exercises
frequently: (1) look up and down (2) slowly roll your eye (3) move
your eyes diagonally.