6
ASSEMBLY & DISASSEMBLY 2
Fig. 6-1 Fig. 6-2
How to Fasten the Slide
(1)After the model is constructed make sure to fasten all the ends of slide to the tubes with the tube screws and screw
driver as Fig. 6-1 shows or double screw driver as Fig. 6-2 shows.
(2) Double Locking Tube (300mm/Red) is the part used to fix the bottom of slide, the nuts on the tube are fixed in a definite
angle. If the tube is misplaced, the tube screws can’t fasten the tube to the bottom
of slide in a proper condition. Please do place Double Locking Tube correctly
as Fig. 7-1 shows while assembly.
1. The Double Locking Tube must be placed so that the arrow
mark on the label would face upward when it is looked from
inside of the model. Please refer to the Fig. 7-2.
2. Fasten the Double Locking Tube to the bottom of
slide with 2 tube screws and double screw driver. Fig. 7-1
Fig. 7-2
label with arrow mark
Parents or guardians must read the instruction manual and the following notice carefully before use in order to
assure safety. And retain them for future reference.
1. Notice for assembly and settlement
Parents or guardians must read the instruction manual carefully and assemble gyms accordingly.
During assembly, be sure to keep small parts away from young kids so that they would not be swallowed.
The gyms are specially designed for indoor use. Please settle it on a flat floor.
Don't settle gyms near a stove or fire.
2. Notice for use
To be used only under parental or guardian's supervision.
To inspect tubes, connectors and fixing parts periodically to make sure they are always well fixed.
To use it only if the structure is stable.
To use it with bare feet to avoid slip.
Don't jump over gym, or from a high position of gym to floor.
Don't play it rudely.
Don't have two or more kids stand or sit on the same single tube at the same time.
These gyms are specially designed for young kids aged one year up to 5 years.
Don't have them used by the ones beyond this age range.
Safety notice
