5
Fig. 5-3
IMPORTANT:
This set is intended for adult assembly only.
Please read all instructions carefully before beginning.
1. Keep unused parts in the marked bag(s) until required. Some parts appear similar and may be confused.
2. Assemble each section separately - as shown in the exploded diagrams.
3. If parts need to be loosened, use the included "RELEASE PLIERS" to assist you.
4. After each section is complete, assemble the completed sections together into the nal unit.
ASSEMBLY & DISASSEMBLY
How to Assemble & Disassemble Tubes and Connectors.
Note: Do not hold a tube or connector
where the insertion takes place, ngers
may be pinched.
Fig. 1 Fig. 2
Fig. 3-1
Fig. 4
(1) Push the corner connector onto the tube
and twist the tube until a "click" is heard.
(2) Finish the assembly of both connectors with
the tube in between.
Then insert the connectors into two separate
tubes to complete a panel.(Fig. 3-1)
Do not assemble the tubes and connectors
one by one. (Fig. 3-2)
(3) Position the RELEASE PLIER nodes over the
holes where the safety lock pins are visible.
Squeeze gently to release the tube from the
connector.
OK (EASY) NG (HARD)
Fig. 3-2
(1) Insert and x the tubes on the back of
the SQUARE FLAT, and then connect the
connectors as Fig. 5-1 shows.
(3) Warning: Keep ngers clear of the gap between the SQUARE
FLATS and tubes when they are being connected. (Fig. 5-3)
How to Fix Fquare Flat onto Fube Frame
Fig. 5-1
(2)When assembling two SQUARE FLAT, the two
at sides should be placed together (Fig. 5-2).
Fig. 5-2
Fig. 5-3
Warning. User Age: 1+
Warning. User Weight: 20kgs max
Warning. Outdoor use / Indoor use
