Glasdon ECO NEXUS Specifications

ECO NEXUS®
OPERATOR INSTRUCTIONS
IMPORTANT NOTE: ENSURE ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO OPERATION.
OPENING YOUR ECO NEXUS
EMPTYING YOUR ECO NEXUS UNLOCKING YOUR ECO NEXUS
LOCKING YOUR ECO NEXUS
SECURING SACK IN POSITION
Using finger lip on both sides
of lid, lift upwards and off
body of container.
Remove lid (as
detailed above).
First, place end of lid opposite to push lock
onto container body ensuring that pin locates
into slot within body (see above).
Push lock end of lid downwards
so that front pin locates into slot
within body.
Finally, push lock center
inwards to lock container.
Release sack from body
and lift out of container.
The confidential paper model
comes complete with push lock.
Using key provided turn in lock
to open.
Lift push lock end of lid
upwards followed by
opposite end. Lift lid off
container completely.
Install correct size sack (approx 16” x 28 ½”
x 40” for both container sizes, available from
Glasdon) by stretching over upper part of
body.
Place lid back onto body
ensuring that sack is neatly
secured underneath lid.
1. 2. 3.
4. 5. 6. 7.
8. 9. 10.

AND NEXUS®ARE TRADEMARKS OF GLASDON GROUP OR ITS
SUBSIDIARIES IN THE U.K. AND OTHER COUNTRIES
Issue 1 July. 2012
©Copyright 2012
Glasdon reserve the right to alter specifications without prior notice.
Glasdon, Inc.
5200D Anthony Road
Sandston
VA 23150
Sales Inquiries: 1-855-USGLASDON
General Inquiries: 804-726-3777
Fax: [phone]
E-mail: [email protected]
Web: www.glasdon.com
HA713/65
IA planned maintenance schedule of regular inspection is recommended,
replacing components as necessary.
IReplacement components are available direct from GLASDON, Inc.
IGLASDON, Inc. cannot be held responsible for claims arising from
incorrect installation, unauthorized modifications or misuse of the
product.
ATTACHING A GRAPHIC HOLDER TO YOUR ECO NEXUS
EMPTYING/REPLACING CUP BANK RESERVOIR
ATTACHING WHEELS TO YOUR ECO NEXUS
INSERTING GRAPHIC
Push graphic holder into
slots provided on either
front or side of container.
Remove lid (see fig. 1). Lift
reservoir out of body using
handle and tip contents away.
From kit provided,
place 1 off screw
through a wheel.
Turn container body upside
down and click screw and
wheel into molded slot.
Repeat with second wheel.
Push 2 off socket caps
into molded recesses
opposite wheels.
Using lip on body as a handle,
tilt container onto wheels to
maneuver container around.
To replace reservoir, locate reservoir holders
into slots on rim of container body. Replace lid
ensuring funnel is located over reservoir.
Push 1 off screw with washer provided through each
hole in lip of body so that screw is protruding outside
of container. Place a second washer over each screw
and secure in postion with wing nuts provided.
Place graphic behind clear
polycarbonate sheet and slide into
graphic holder so that the lugs
locate in the holes along the bottom
of the graphic holder.
11. 12.
14. 15.
16. 17. 18. 19.
13.