Glendale GL1802 User manual

Page | 1
Please check if you have all the fittings listed below
Component Parts
Please check if you have all the parts as listed Note: The quantities below are the correct amount to
complete the assembly. In some cases more fittings may be supplied than are required.
GL1802 Highfield gazebo 3x4m Assembly Instructions
If you need help with assembly or missing parts please contact our customer care team on:
[e-mail]
IMPORTANT –Please read these instructions carefully before assembling
WE RECOMMEND 2 PEOPLE TO ASSEMBLE THIS GAZEBO

Page | 2
Dimensions EXTERNAL
Width
300 cm
Depth
400 cm
Height
250 cm
Assembly Requirements
Number of people required to assemble
2
Approximate assembly time
45-1 Hour
If you need help with assembly or missing parts please contact our customer care team on:
[e-mail]

Page | 3
Assembly Instructions
Step 1 & 2
Connect the upright leg (1)
With the foot plate part (10)
Add clip (14) to the top of the
leg and to all the pre-drilled
legs as shown
Do not over tighten the
screws at this stage
Step 3 & 4
Add the cross supporting
members by connecting
using inserts G & F
Add the supporting side parts
(5)
And add the curtain tracking
bar to the inside of the frame
If you need help with assembly or missing parts please contact our customer care team on:
[e-mail]

Page | 4
Step 5
Step 6
The Vintage gazebo is now
ready to add the roof and
curtains. First apply the roof
canopy (M) simply throw the
roof over the top section and
spread it out so that all the
corners are close to the roof
bars. The easiest way to
secure the roof is to pull the
canopy over using the
elasticated ends and secure
the mid sections first, always
making sure the canopy is
even across the roof leaving
the 4 corners until last. For
the curtains undo each
section (as they are all zipped
together and from the internal
(inside) one curtain fits every
corner across one leg so
when zipped it will all join up.
If you need help with assembly or missing parts please contact our customer care team on:
[e-mail]
Now make the spider roof
support frame part (16)
Connecting all the roof poles
ensuring the corner poles
Part 8 are positioned to
attach the frame into the
corner.
Simply slot these in and then
lift the poles onto the frame
Secure the frame with bolt H2

Page | 5
Distributed by:
Glendale Leisure
46 Barn Street, Digbeth
Birmingham B5 5QB
www.Glendale-leisure.com
Safety and Care Advice
Your Gazebo frame can be left outside all year round but we advise the curtains & Canopy are taken off
during the winter months and stored in a cool dry frost free place (do not store wet). This will prevent
them from deteriorating. (To keep the canopy refreshed use a water proofing spray on the outside of the
roof & curtains at least 3 times a year) Available at all good tent/camping shops.
*VERY IMPORTANT YOU MUST SECURE YOUR GAZEBO TO THE GROUND AS SOON AS IT IS BUILT –in heavy winds remove the canopy to avoid
wind damage –Do Not BBQ under this gazebo
To secure to grass use the tent pegs provided for hard surface patios fixing bolts must be used.
FOR SPARES OR REPLACEMENT CANOPIES PLEASE CONTACT US, THANKS FOR PURCHASING THIS GAZEBO.
If you need help with assembly or missing parts please contact our customer care team on:
[e-mail]