The Push Button Splashproof Cap is
designed for above water use only.
Simply depress the rubber cap to
turn ON or OFF to cycle through
the multi-mode functions. This cap
is equipped with a STRONG 40cm(15.7”)
DETACHABLE LANYARD.
The Twist ON/OFF Waterproof Cap allows the
GLO-TOOB to be switched ON or OFF under-
water at any depth. CAUTION: TAKE CARE
TO ONLY TURN THE PLASTIC CAP WHILE
UNDERWATER SO AS NOT TO LOOSEN
THE CAP AND CAUSE ACCIDENTAL
FLOODING. This cap is equipped with an
EXTRA STRENGTH STAINLESS STEEL
ATTACHMENT RING.
When the cap is not in use, use the protector cover to ensure
no water comes in contact with the conductive threads.
Push Button Splashproof Lanyard Cap Twist On/Off Waterproof Cap
CAP SPECIFICATIONS
Push Button Splashproof
Lanyard Cap
Detachable Lanyard & Clip Large Stainless Steel split-ring
Yes Yes
Low impact
Push button Twist ON / OFF
Splashproof 3,500 meters (11,500 feet)
1 x Nitrile washer
1 x Nitrile washer
Twist On/Off Waterproof Cap
Waterproof
Seal type
Attachment type
Switch type
Strength
Working temperature
Aircraft grade aluminum
with hard coat anodizing
Low impact
Thread
Protector Cover
-20 C to +80 C (-4 F to 176 F ) -20 C to +80 C (-4 F to 176 F )
The manufactures of GLO-TOOB warrants each GLO-TOOB to be free from defects in material and workmanship.
Under this warranty the manufactures of GLO-TOOB obligation is limited to replacing or repairing any GLO-
TOOB returned to us and found to be defective in either material or workmanship.
This warranty excludes the following: 1. Battery Leakage (determine the brand of the battery and follow
that battery manufacture’s instructions on how to make a damage claim). 2. LED Burnout. 3. Failure of or
damage to GLO-TOOB due to misuse and/or lack of maintenance. 4. Accidental flooding of the GLO-
TOOB by exposing the battery chamber to moisture/water.
For WARRANTY INFORMATION or REPAIR INSTRUCTIONS, please visit out our website at:
www.glo-toob.com
In order to prolong the life of your GLO-TOOB, it is recommended that preventive maintenance is
performed on a periodic basis as follows:
1. Exposure to Saltwater
After saltwater exposure it is highly recommended that the GLO-TOOB is rinsed in fresh water and
then dried before opening. This will reduce the possibility of corrosion and extend the life of your
GLO-TOOB.
2. Contact surfaces
All GLO-TOOB caps have conductive aluminum threads to hold the caps in place as well as to
conduct power. Should the threads come into contact with water, an aluminum oxide layer will be
formed around the threads possibly rendering the contact area faulty. For this reason please make
sure the threads stay dry and clean. Use the universal protector cover to keep threads dry and clean
when not in use around wet environments.
3. Washer (seal)
The washer on the inside of the caps must be checked each time before the GLO-TOOB is
submersed in water. If the washer is cracked or cut, replace the washer immediately. Also check for
general cleanliness of the washer to ensure that particles do not affect the watertight seal.
4. Battery
Leaking batteries can corrode the inside of your GLO-TOOB. It is therefore recommended that
you open your GLO-TOOB once a month and check the battery for signs of leakage and / or
corrosion. It is also recommended that you remove the batteries from your GLO-TOOB and store
them separately if you use your GLO-TOOB infrequently.
Care and Maintenance
LIMITED LIFETIME WARRANTY
