GLOBAL FURNITURE ALLIANCE Houston Dual Powered Zero Gravity Recliner User manual

GLOBAL FURNITURE ALLIANCE
ASSEMBLY INSTRUCTIONS
Houston Dual Powered Zero Gravity Recliner
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
This product is designed to seat people up to a maximum of 115kgs (18 stone)
Check and re-ghten parts/nuts & bolts every three months
For any assistance with assembly, please contact Global Furniture Alliance on 01291 645080
Opon 2 or email [email protected]om
Alternavely you can go to the following websites:-
• www.youtube.com (YouTube Channel - Global Furniture Alliance)
• www.gfa.uk.com (Product Ranges - Assembly instrucon Videos)
For any missing/damaged parts, please contact your retailer
FIRE RETARDANCY
GFA’s leathers/bonded leathers/PUs/fabrics meet the requirements of BS5852 Part 1 Source
0 ( Cigaree) Ignion Source 1 (Match) as laid out in the UK Furniture and Furnishings (Fire)
( Safety) Regulaons 1988 with amendments in 1989, 1993 and 2010.
Please retain these instrucons for future reference and in case of any queries, please quote the
following batch number to your retailer.
(The batch number is also located on the underside of the seat pad or footstool pad)
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
IMPORTANT: Please read this manual carefully before beginning assembly of this
product. Keep this manual for future reference.
SAFETY INFORMATION
Idenfy all the parts and hardware.
Do not discard of the packaging unl you have checked that you have all of the parts and hardware
required.
Hardware package may have spare parts.
WARNING:
This item contains small parts which can be swallowed by children and pets. Keep children and pets away
during assembly.
To avoid danger of suocaon, always keep plasc bags away from children and pets.
We recommend that you assemble this unit on a carpeted oor to avoid scratches.
We do not recommend the use of power tools for assembly as this could damage the unit. Only use manual
tools.
Requires 2 people for ease of assembly.
CARE AND MAINTENANCE
Wipe regularly with clean water and a damp, clean, so white cloth
General cleaning can be done as needed with a mild detergent and water soluon. Always rinse with clean
water and dry
For heavy soiling, dampen a so white cloth or so bristle brush. Use care as scrubbing can damage the
surface
More dicult stains can be treated, but this should be occasional, not daily, cleaning
ANY cleaning soluon used must be removed with clean water and a clean white cloth
Cleaning residue le on the material can cause it to dry out and crack, or aect the colour
DO NOT use any cleaners with corrosive ingredients (lye, acids or ammonia).

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
PRE-ASSEMBLY INFORMATION
PARTS DESCRIPTION
Seat
Qty1
Chair legs
Qty1
Chair spindle
Qty1
Power supply cord
Qty1
Power supply
Qty1
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
A B C
D E

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
ASSEMBLY
STEP 1
STEP 2
Lay the chair and insert the plug as shown on diagram

STEP 3
ASSEMBLY
Normal charging procedure:
1) Connect the power pack to the charger ensuring the correct port is used. The
plug should t securely in place.
2) Connect the mains power cable to the charger and pluf the unit into the wall.
The chargers LEF light will turn on and show RED. The LED light may inially ash
during the rst few minutes of charging but should become solid RED as the charh-
ing process iniates.
3) Once the power pack is fully charged, the LED light will turn GREEN indicuang
the charing cycle is compleye. Typical charing me may take approx. 3-6 hours.
4) To prevent damage to the baery and to prolong the life of the baery ,discon-
nect the charger once the charging cycle is completed. Addionally, onlu use the
charger specied by OKIN Rened.

STEP 4
ASSEMBLY
Be sure to charge the baery rst, before using the chair.
CAUTION: Disconnect AC adapter from power pack once charging cycle is complete
STEP 5
FEATURE: Swivel base - complete 270 degree turning circle

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
USER GUIDE
1.
2.
3.
4.
5.
Raises ooman
Recline chair
Return to upright posion
Stow ooman
HOME: Return to the upright
posion and stow the ooman
at the same me
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
USER GUIDE
HOW TO ADJUST THE HEADREST
Grip the backside of the headrest and pull forward
from both sides as shown
DO NOT pull from the side edges as the material
may tear
To adjust the headrest backwards, push on both
sides or use forearm to evenly move the headrest
CAUTION: Do not push in the centre of the headrest as
this may cause the cushion to collapse
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM

USER GUIDE
INSTRUCTIONS FOR USING RECHARGEABLE POWER PACK
1. Please read and follow the instrucons carefully before inial use of the rechargeable power pack.
2. The power pack typically has about 75% power at the me of manufacturing. Prior to its rst use it is important to
fully charge the power pack by following the steps listed below.
3. Normal charging procedure;
• Connect the power pack to the charger ensuring the correct connecon port is used. The plug should sit securely
in place.
• Connect the mains power cable to the charger and plug the unit into the wall. The charger’s LED light will turn on
and show red. The LED light may inially ash during the rst few minutes of charging but should become solid
red as the charging process iniates.
• Once the power pack is fully charged the LED light will turn green indicang the charging cycle is
• complete. Typical charging me may take approximately 3-6 hours.
• To prevent damage to the baery and to prolong the life of the baery, disconnect the charger once the charging
cycle is completed. Addionally, only use the charger specied and by OKIN Rened.
4. Should the power pack not funcon properly, only a qualied technician is permied to service the
system. The warranty will be void should the unit be tampered with or modied in any way.
5. The power pack will omit an audible low voltage warning where it will beep connuously for 30 seconds once the
charge has been depleted below operaonal levels.
6. The Power Pack has a short circuit protecon system. Should the system experience a short circuit
situaon, power will be cut automacally. An audible short circuit warning beep will be omied at 30
second intervals and will connue unl the cause of the short circuit has been removed.
7. The power pack has an overload protecon system. Should the system experience an overload
situaon, power will be cut automacally. An audible overload warning beep will be emied for 30 seconds and the
system will go into reset once the cause of the overload has been removed.
8. Depending on operaonal condions and usage, the power pack can be recharged approx. 300 mes.
9. Should the power pack be used in a system consisng of a microprocessor or other kinds of IC such as touch sen-
sors or belt sensors, the baery may require more frequent charging than normal as those
systems are always acve and connuously consume power from the power pack. In these cases, if it is important
to recharge the Power Pack every 1-2months. Should it be ancipated that the system will sit idle for longer than 2
months, it is recommended that the power pack be disconnected from the system to prevent complete depleon of
the charge. A power pack coming from storage should be fully charged prior to being connected to a drive or control
system.
10. It is possible that aer long periods of storage, several cycles of charging and recharging may be
required to restore the performance of the baery.
11. A fully charged and unconnected power pack is capable of being stored for up to 6 months when
kept in a dry environment with the temperature ranges of 0-45°C (32-113°F).
12. For opmum performance, a power pack should be used at room temperatures ranging from 20-25°C (68-77°F).
The operang temperature should never exceed 40°C (14°F).
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
SAFETY NOTICES
CAUTION: Leaking baeries present a health hazard and can cause
burns to skin and eyes. Baery uid is harmful when touched or
swallowed. If you come into contact with baery uid, clean the
aected area with water and contact a doctor
CAUTION:
Keep baeries out of reach of children
CAUTION: Do not open or destroy the baery in any way. Do not
expose the baery to heat or to an open ame. Do not solder or weld
in the vicinity of the baery
CAUTION:
Do not short circuit the baery
CAUTION:
• Immerse the baery in water
• The baery should not be exposed to mechanical vibraons
• Improper storage can reduce the performance or permanently
damage the baery
NOTICE:
The power pack must be charged within six months of the producon
date and/or charged immediately upon delivery and then aer six
months of storage. For some drive systems, a minimal level of current
may ow even when the drive is not being used. Aer a prolonged
period this can lead to a severely low charge on the baery that may
reduce the performance or permanently damage the baery.
CAUTION:
The connecon cable for the baery should be disconnected from the
control unit or drive if the system will not be used for an extended
period of me. This will reduce the rate at which the baery will lose
its charge.
The baery should be disposed of properly. Do not dispose with
normal household waste!
T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM

T: 01291 645080 | F: 01291 645099
E: [email protected] | W: WWW.GFA.UK.COM
WARRANTY
Thank you for purchasing a product from Global Furniture Alliance. These products have been made to
demanding, high-quality standards and are guaranteed for domesc use against manufacturing faults for a
period of 12 months from the date of purchase.
This warranty does not aect your statutory rights.
We reserve the right to repair or replace the defecve product, at its discreon.
This product is guaranteed for 12 months if used for normal purposes. Any warranty is invalid if the product
has been overloaded or subject to neglect, improper use or an aempted repair by other than an
authorized agent. Heavy-duty or daily professional/commercial usage are not guaranteed.
Due to connuous product improvement, we reserve the right to change the product specicaons without
prior noce.