Goldair FT365 User manual

StainlessSteelToaster
4Slice
Models: FT365
Operating Instructions

ALWAYS
✔Always ensure hands are dry before
handling the plug or switching on the Toaster.
✔Always use the Toaster on a secure, dry,
level surface.
✔Always allow adequate air space above
and on all sides for air circulation. Do not
allow the Toaster to touch curtains, wall
coverings, clothing, dishtowels or other
flammable materials during use. Do not use
under cupboards or curtains.
✔Caution is required on surfaces where
heat may cause a problem –an insulated
heat pad is recommended.
✔Always use the Toaster with the crumb
tray in place.
✔Clean the crumb tray regularly. Do not
allow crumbs to build up.
✔Always unplug from the socket when not in
use and before cleaning.
✔Always allow the Toaster to cool before
cleaning and storing.
✔Carry out regular checks of the supply
cord to ensure no damage is evident.
✔Return the Toaster after a malfunction, or
if it has been damaged in any manner to an
authorised electrician for examination, repair
or adjustment as special purpose tools are
required.
NEVER
✘Never touch hot surfaces.
✘Never use this appliance outdoors.
✘Never use this appliance for any purpose
other than its intended use. This appliance is
for household use only.
✘This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge, unless
they are supervised or have been given
instruction concerning the use of the Toaster
by a person responsible for their safety.
✘Close supervision is necessary when the
appliance is near children.
✘Never leave the appliance unattended
when in use as bread may burn.
✘Never place this appliance on or near a
hot gas or electric burner or where it could
touch a heated oven or microwave oven.
✘Never use this appliance with any
foodstuff containing sugar or products
containing jam or preserves.
✘Never immerse any part of the Toaster, or
cord set and plug in water or any other liquid
to protect against electrical hazards.
✘Never use harsh, abrasive or caustic
cleaners to clean this appliance.
✘Never operate the appliance with a
damaged cord or plug, after it malfunctions,
or if it has been damaged in any manner.
✘The Toaster is not intended to be operated
by means of an external timer or separate
remote-control system.
Thank you for choosing a GOLDAIR Electric Toaster. This GOLDAIR
appliance has been designed and manufactured to high standards of
engineering and with proper use and care, as described in this leaflet, will
give you years of useful service. Please read these instructions carefully.
CAUTION:
This appliance generates heat during
use. Proper precautions must be taken
to prevent the risk of burns, scalds, fires
or other damage to persons caused by
touching the exterior whilst in use
General care and safety guide
TECHNICAL SPECIFICATION
Model No: FT365
Power Supply: 220-240V ~ 50Hz AC
Power: 1260-1500W
WARNING: Never attempt to extract
jammed toast, or any other item with a
knife or any other object, as contact with
live elements could result in an electric
shock. Allow the appliance to cool, unplug
and carefully turn the toaster upside down
and shake gently to remove the bread.

Components
Bread Slots
Housing
Carriage Control Levers
Stop Buttons
Defrost Buttons
Reheat Buttons
Browning Adjustment Control
Base
Crumb Trays
Before first use
Carefully unpack the toaster and remove
all packaging material, including the
protective film over the stainless housing.
Remove any manufacturing residue or dust
with a clean, soft, damp cloth.
Be sure to read this user manual
thoroughly.
It is normal for a slight odour to be emitted
on the toaster’s first few uses. This is due
to manufacturing residues. We suggest
you operate your new toaster a few times
without bread to help eliminate this normal
odour.

Operating your Toaster
•Position the toaster on a dry, stable level
work surface, away from the edge.
Ensure that the cord does not over-hang
the work surface as this is a hazard.
•Insert the plug into a suitable power
outlet, 220-240V.
•Insert the bread, crumpets or bagels into
the bread slots.
•Using the Browning Adjustment Control,
select the desired browning setting;
toasting settings range from 1 (lightest)
to 7 (darkest). When using the toaster for
the first time, select setting 3. Varying
types of bread and personal preference
may require a different setting.
•Press the Carriage Control Lever down
until it locks into place. The toasting
cycle can be stopped at any time by
pressing the Stop button.
•Remove the toast taking care not to
touch any hot surfaces. In the unlikely
event that bread or crumpets becomes
jammed, switch the toaster off at the
power outlet and disconnect the plug.
Allow the toaster to cool fully before
carefully turning the toaster upside down
and shaking gently to remove the
jammed items ensuring that you do not
damage the element. Never insert your
hands or any hard or sharp instrument
into the slots.
•If the toast starts to smoke before it has
popped up, stop the toasting process by
pressing the Stop button.
•The Reheat button is designed to reheat
the toast without cooking it further.
•Dry or thin slices will toast quicker than
moist or thick slices, so use a lower
browning control setting.
•When toasting two slices at the same time,
try to use the same size and consistency of
bread to achieve equal browning.
•The Defrost button is designed to first
defrost, then toast the bread. This will
extend the toasting cycle slightly. Press the
bread carriage lever down until it locks into
position, then press the defrost button so
the light illuminates. When the cycle is
complete the bread carriage will raise the
toast up. If you wish to stop the defrosting
before it is finished, simply press the Stop
button.

•Toasting is a combination of cooking and
drying the bread. Moisture levels differ
from one bread to another, which can
result in varying toasting times.
•For slightly dry bread, use a lower setting
than normal.
•For fresh bread or whole wheat, use a
higher setting than normal.
•Breads with very uneven surfaces (such
as English muffins) will require a higher
setting.
•Thickly cut pieces of bread (including
bagels) will take longer to toast. Very
thick pieces may require two cycles.
•When toasting raisin or other fruit breads,
remove any loose raisins from the surface
of the bread before placing into the
toaster to prevent pieces falling into the
toaster or sticking on the guard wire in the
slot.
•Before toasting bagels, slice each bagel
into two equal halves.
•If you are toasting a single slice of bread,
select a lighter setting than normal to
avoid over toasting. The toaster is
designed to heat the whole toasting
chamber for two slices.
•Frozen breads, i.e. waffles and bagels
should be warmed using the defrost
button.
Toasting tips
SUPPORT AND TECHNICAL ADVICE
North Shore City, Auckland, New Zealand
Monday –Friday 8am-5pm
Phone: [phone]
Website: www.goldair.co.nz
Care and cleaning
•Unplug the toaster from the power outlet
and allow to cool before cleaning.
•Do not use abrasive cleansers. Simply
wipe the exterior with a clean, soft damp
cloth and dry thoroughly.
•To remove crumbs slide out the crumb
tray and discard crumbs. Wipe clean and
replace, ensuring tray locks into place.
•Never operate the toaster without the
crumb tray in place.
•To remove any pieces of bread remaining
in the toaster, turn the toaster upside
down and shake gently. Never insert any
hard or sharp instrument into the slots as
this could damage the toaster and cause
a safety hazard.
•Never wrap the cord around the outside of
the toaster.
•Do not try to clean inside the bread slots
as this may damage the elements.

Your Goldair product has been inspected and
tested and is guaranteed subject to the
following for a period to two years from the
date of purchase against defects in
workmanship and materials. During this
period, such defects will be rectified by repair
or replacement of the product purchased.
Your product contains no user serviceable
components and this warranty becomes
invalid if in our opinion the product has been
misused, abused, incorrectly installed,
tampered with, connected to an electrical
supply not corresponding with the name plate
specification, or subjected to power surges.
The warranty does not include any labour or
other associated expense that may be
involved in removal or installation of the
product. Normal wear and tear is expressly
excluded.
If your Goldair product fails to operate
satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a
repair or replacement product under this
warranty, you will need to produce satisfactory
evidence of date of purchase. The completed
warranty and purchase receipt must be
presented with the product. The warranty
should be filled out at the time of purchase. It
is in your interest to make sure this is done.
If the product is to be replaced (cannot be
repaired) then that replacement will be of the
same or similar product or accessory
excluding packaging, instruction card etc.
Where a replacement product is supplied, this
shall be guaranteed for the balance of the
original warranty period.
Any model that is no longer available will be
replaced by a model of a value and with such
features as we consider appropriate in the
circumstances. Goldair Ltd is not responsible
for freight forwarding charges, losses or
damage in transit.
If service is required after the warranty period
has expired, the product should be returned to
a qualified electrical technician. Service
outside of the warranty period will be at your
cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers
are advised that: The manufacturer does not
undertake that repair facilities and parts are
necessarily available for this product.
If any of the provisions of the foregoing are
contrary to any relevant legislation, then that
provision shall be deemed to be excluded from
the warranty and the rest of the provisions will
continue to apply.
Name ………………………………………………
Address ……………………………………………
……………………………………………………….
Suburb ……………………………………………
Purchased from …………………………………
Date of purchase …………………………………
Name of product …………………………………
Model no ……………………………………………
IMPORTANT: Please retain this warranty card
Two year warranty