Goosky T8 User manual

INSTRUCTION MANUAL
使用说明书
Thank you for choosing Goosky Technology series products. Before
entering the remote control world, you must be told a lot of relevant
knowledge and precautions to ensure that you can be more comfortable in
the learning process. Before starting the operation, please read this manual
carefully. We believe it will be of great help to you. Please keep this manual
properly for future reference.
感谢您选用谷天科技 系列产品。
进入遥控世界前必须告诉您许多相关的知识与注意事项,以确保您能够在学
习的过程中较得心应手。在开始操作之前,请务必详细阅读本说明书,相信
一定能够给您带来相当大的帮助,也请您妥善保管这本说明书,以作为日后
参考。
#2 BY DESIGN
2022

2
EN WWW.GOO-SKY.COM
Transmitter description -1 遥控器说明 -1
D/R
70%
85%
100%
Pose mode
Manual mode
Manual mode
遥控器
Remote Control Power Light(Red)
POWER-1
A
POWER-2
B
Flying Ring
Throttle, Orientation Front Back, Left Right
IDLE HOLD
D/R
70%
85%
100%
Pose mode
Manual mode
Manual mode
遥控器
Remote Control Power Light(Red)
POWER-1
A
POWER-2
B
Flying Ring
IDLE HOLD
(MODEL 1 )
(MODEL 2 )
Throttle, Left Right
Front Back, Orientation

3
EN WWW.GOO-SKY.COM
提手
音频接口 充电接口
(Diameters) 外形尺寸长: L153*W93*H154
(Radio Frequency) 无线频率: 2.404GHz--2.4475 GHz
(Transmit Power) 发射功率: < 20 dBm
(Weight) 重量约: 335g
(Modulation Mode) 调制方式: 2FSK
(Spread Spectrum Mode) 扩频方式: s- FHSS
(Working Voltage) 工作电压: 3.7V
(Remote Distance) 遥控距离: 300m
(Charge Interface) 充电接口: TYPE-C
(Low Voltage Alarm) 低电压报警: 3.35V
(Battery Type) 电池类型: Lithium Polyer Battery
(Battery Capacity) 电池容规格: 2800mAh 3.7V
(Product Model) 产品型号: T8
遥控
(Coach Interface) 音频接口: PPM 输出
Handle
Charge Interface
audio port 5V <2A
153
154
93

4
EN WWW.GOO-SKY.COM
Transmitter description - 3 遥控器说明 - 3
Push down the battery compartment cover,
take out the 18650 lithium battery, and
remove the battery protective film;
电池 电池 揭
掉电池保护膜
The protruding end (+) pole and the plane end (-) pole of the battery shall be installed
into the battery compartment according to the marked direction in the battery
compartment;
电池-电池电池电池
Protruding end
Flat end
电池
Push down
!
CAUTION

BIND
5
EN WWW.GOO-SKY.COM
Transmitter description - 4 遥控器说明 - 4
Turn on and off: press and hold power-1 (a) and power-1 (b) at the same time to turn on the
power of the remote control (turn on), or turn off the power of the remote control (turn off);
按 POWER-1 A POWER-1 B遥控器 ( )遥
控器 ( )
Turn on the GOOSKY T8 transmitter, press the BIND button for 3 times after the helicopter is
powered on. The blue light flashes quickly. Keep the transmitter less than one meter away from
the flight control. The flight control passes self-detection when the blue light is solid on. Then
the binding is done.
T遥控器 连按3次 按遥控器控
控
遥控器开机、关机介绍
Turn on and off the remote control
飞控对频介绍
Introduction to flight control binding
D/R
70%
85%
100%
Pose mode
Manual mode
Manual mode
遥控器
Remote Control Power Light(Red)
POWER-1
A
POWER-2
B
Flying Ring
Throttle, Left Right
Front Back, Orientation
IDLE HOLD
(MODEL 1 )

6
EN WWW.GOO-SKY.COM
Transmitter description - 5 遥控器说明 - 5
指示灯灯语介绍
Introduction to indicator light
遥控器
Remote Control Power Light(Red)
Introduction to indicator light
5-
5-5
5-5
-5
1When only the red light of the power indicator is always on, it should be charged in time to avoid
affecting the use;
t is recommended to store 5 o te atter poer and repenis te atter poer
eer monts to aoid oer discare o itim atter
5

MODE1 MODE2
7
EN WWW.GOO-SKY.COM
Transmitter description - 6 遥控器说明 - 6
左、右手 互换
Mode1 and mode2 are interchangeable
MODE1 MODE2
!
CAUTION
1:Disassemble the left and right assembly seats of the remote control, and
unplug the connecting wire plug;
遥控器
Te et and rit assem seats are instaed intercanea
and ten te assem seat is assemed on te ront se and
te connectin ire is inserted
dst te positions o mode and mode sit e sitces to
correspond to te et and rit ands o te remote contro one
one
遥控器
ter assem recairate te rocer
(MODEL 2 )

8
EN WWW.GOO-SKY.COM
Transmitter description - 7 遥控器说明 - 7
左、右手 互换
Mode1 and mode2 are interchangeable
MODE1 MODE2
(MODEL 1 )
MODE1 MODE2
!
CAUTION
1:Disassemble the left and right assembly seats of the remote control, and
unplug the connecting wire plug;
遥控器
Te et and rit assem seats are instaed intercanea
and ten te assem seat is assemed on te ront se and
te connectin ire is inserted
dst te positions o mode and mode sit e sitces to
correspond to te et and rit ands o te remote contro one
one
遥控器
ter assem recairate te rocer

9
EN WWW.GOO-SKY.COM
Transmitter description - 8 遥控器说明 - 8
校准摇杆
Introduction to indicator light
POWER-1
A
POWER-2
B
POWER-1
A
POWER-2
B
进入校准模式
Enter calibration mode
摇杆校准
Rocker calibration
1The remote control is turned off;
遥控器
Trn te to rocer arms to te otside ire 8 as son in te arro direction and trn
on te poer o te remote contro at te same time trn on
遥控器
t tis time te remote contro i send ot eep sond and enter te cairation mode
遥控器
4Turn the left and right rocker rods along the red line for two circles at the maximum range, then put the accelerator
rocker rod at the lowest position, and the lifting rocker rod will naturally return to the center;
Te remote contro emits didi sond cairation is sccess and eit
遥控器

10
EN WWW.GOO-SKY.COM
Memo 备忘录

2022
www.goo-sky.com
Zhongshan Goosky Technology Innovation Co., Ltd.
Other manuals for T8
1
Other Goosky Drone manuals