Gorenje DVG 6565 User manual

EN 1
OPERATION AND MAINTENANCE
MANUAL
Dear customer,
You have purchased a product of our new
series of cooker hoods. We hope that our
product will serve you well and for long time.
We recommend you to study these
instructions and to operate this product
according to them.
IMPORTANT INFORMATION AND
RECOMMENDATIONS
The cooker hood should not be connected
to smoke flue, which is used for combustion
exhaust
The appliance can be used in exhaust
mode (the exhaustion of exhalations into
waste air stack) or, after additional buying
of carbon filter and recirculation set in
recirculation mode (circulation through
carbon filter).
If there is in operation simultaneously with
the cooker hood (in exhaustion mode)
appliance of type B in the same room -
heat source (for instance with gas, oil,
diesel fuel or with solid fuel), which draw
combustion air directly from the room, then
it should be taken into account, that these
appliances create at combustion a certain
level of under-pressure. Therefore it is
necessary to provide a sufficient inflow of
air (from the outside environment).
The cooker hood is an electric appliance
with Y –type connection. If the power cord
is damaged, it should be replaced with the
producer, his/her service technician or with
similarly qualified person, for to prevent the
creation of dangerous situation.
Do not handle with open flame under the
cooker hood (for instance at flambéing
etc.)!
Do not use hot plates (burners) under hood
without pots!
The big fat deposits from roasting on the
grease filter should be regularly removed.
The accessible parts could be hot at using
of cooking devices.
This appliance is designed for normal
household use.
Follow the below determined instructions at
replacing of filters.
This appliance should be operated with
adults only.
This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand
the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
The producer is not responsible for
damages caused with faulty installation or
faulty using of appliance.
ATTENTION
Plug in cooker hood to the net before fixing
on the wall and check function of motor (all
speeds) and function of lights.
Check whether motor is not too
noisy, whether have regular running.
Do not remove protection foil from cooker
hood and decoration chimney.
Check if carton box is not damaged, check
surface of cooker hood if there are not
scratches or dishing.
IN CASE OF FAILS DO NOT FIX COOKER
HOOD ON THE WALL AND CLAIMED IT AT
YOUR SALER!!!
Fix the cooker hood on the wall with
protection foil. After fixing and setting right
height of decoration chimney remove
protection foil.
Do not move with decoration chimney
without protection foil. In other case there
will be scratches on surface.
Following these instructions you avoid
useless claiming.
DESCRIPTION (FIG.1)
A –Cooker hood
B –Lower part of decoration chimney
C –Upper part of decoration chimney
D –Lifting off door
E –Carbon filter (for recirculation only)
F –Grease filter –metal cassette
M –Cover of decorative chimney
G –Seal
ELECTRIC CONNECTION
Check before installation of appliance that
the voltage in your power net corresponds
to data given on the production sheet inside
of the appliance.

EN 2
The appliance is provided with a power
cord is ended with a plug –class I. of
protection against electric shock.
Connect the appliance to a socket
corresponding to valid national standards.
INSTALLATION
The distance between the cooker hood and
the hotplate should not be less as:
450 mm over electric the hob (fig.2)
650 mm over gas burners (fig.2)
ATTENTION
The attached dowels and screws are
designed for fastening of cooker hood on a
wall from concrete or full bricks. For other
wall material a corresponding type and size
of dowels and screws should be used.
Leave the fastening of cooker hood to a
specialist!
When installing cooker hood do not keep it
by glass front surfaces!
MOUNTING OF COOKER HOOD
Remove cooker hood from the packaging.
A part of packaging is the mounting guide –
see fig. 3.
Open the cooker hood and take off the fat
catching metal filter.
Place the mounting guide on the wall
(bottom edge of guide = bottom edge of
cooker hood) and mark the location of
openings for the dowels in the required
height.
Drill the openings for the dowels on the
marked places „G“ and „H“. Tap the dowels
into the bored openings.
Screw in the screws into the dowels in the
openings „G“ and hang up the cooker hood
on them.
Lock the location of cooker hood with two
screws in the openings „H“.
IMPORTANT
The horizontal location of cooker hood
should be observed.
THE EXHAUSTION VERSION
At use of exhaustion version (see fig. 4) the
exhalations are led into the exhaustion
opening with the exhaustion hose, which is
connected to the cooker hood with a
flange. The exhaustion hose and the
fastening clips should be bought
additionally.
The exhaustion is provided through the
upper outlet of the cooker hood, on which
the exhaustion hose should be connected
and the other end of hose should be
connected into the exhaustion opening.
The diameter of exhaustion hose should be
the same as the diameter of connecting
flange –e.g. 150 mm, or Ø 120 mm with
a reduction piece (if you use connection
hose Ø 120 mm , you will decrease
exhaust capacity and increase noise level)
MOUNTING OF EXHAUSTION
VERSION AND OF DECORATION
CHIMNEY
Fasten with help of a hose clip on the
hinged on cooker hood the one end of
exhaustion hose, fasten the other end into
the exhaustion opening.
Both parts (the upper C and lower B) of
decoration chimney, shifted one to the
other, place on the hinged on cooker hood.
Shift the upper part C into the required
height, mark the upper location and mark
the fastening openings of console (K).
Remove the decoration chimney and bore
the marked openings for the dowels.
Screw on the console (K) together with
cover of decoration chimney (M).
Fasten once more the both parts of
decoration chimney, shift out its upper part
and fasten to the console with two screws.
IMPORTANT
Remove protection foil from decoration
chimney not until last assembly of
decoration chimney!
IMPORTANT!
The carbon filter should not be installed in
the cooker hood at exhaustion version.
RECIRCULATION VERSION
A carbon filter and recirculation set should
be bought for the cooker hood in
recirculation version (fig. 9). The
exhalations are exhausted through the
carbon filter.(fig. 1 (E)) The circulation air
with removed smell is led with exhausted
hose through air spreader to the ventilation
openings in upper part of decorative
chimney to the room.

EN 3
This version is used in cases, when there is
no waste air stack at disposal.
CAUTION!
The carbon filter should be installed in the
cooker hood at recirculation.
CONTROL (FIG. 6)
S –sensor of switching on/off function (sensor
of power switch)
L –sensor of light switching on/off function
1, 2, 3 –sensors for setting on of capacity
level
P –sensor of increased capacity function
(BOOSTER)
F –signal light for signaling the pollution level
for the filter
C –sensor of CLEAN and FRESH function
T –sensor of TIMER
CAUTION
The sensor touch control is activated with
single placing of finger on the
corresponding symbol on the control board.
Therefore keep the control board clean and
dry.
Do not allow to children the use or cleaning
of appliance.
PREVENT the undesired switching on of
appliance, for instance with pets!
The set up parameters will be set to zero at
disconnection of cooker hood from the
power.
The capacity of cooker hood can be
regulated in four levels using the touch
symbols on the control board. The
reaction time of symbols is 0.5 seconds –
this is the necessary time for holding the
finger on the corresponding symbol.
SWITCHING ON OF COOKER HOOD
The sensor S is shining with lower
intensity after connecting the cooker
hoods to the power net. With pressing the
S sensor (power switch) the cooker hoods
will be switched on –the control board will
shining and activated.
SETTING UP OF CAPACITY LEVEL
FOR THE COOKER HOOD
Using of sensors 1- 3 we can set up the
capacity level after switching on of the cooker
hood.
BOOSTER –FUNCTION OF
INCREASED CAPACITY
The function „BOOSTER“ is used for fast
switching on of the maximal capacity for the
cooker hood.
The „BOOSTER“ function is activated with
pressing of „P“ symbol.
The duration of cooker hood operation in
this mode is max. 6 minutes. After elapsing
of this period the capacity will be
automatically decreased to level 3.
DEACTIVATION –CANCELLING OF
„BOOSTER“ FUNCTION
The „booster“ function is cancelled with
pressing one from symbols 1, 2 or 3.
SWITCHING ON LIGHTING OF THE
COOKER HOOD
After switching ON of cooker hood press
sensor “L”.
SWITCHING OFF LIGHTING OF THE
COOKER HOOD
The lighting of cooker hood can be switched
off with pressing of sensor „L“.
TIMER
The TIMER function is used for automatic
switching off of the cooker hood.
The function is activated with pressing of
sensor „T“
The capacity level can be changed at used
timer function.
The operation duration of cooker hood in
this mode is 30 minutes.
The cooker hood will be switched off
automatically after elapsing of this time
period.
METHOD
Switch on the cooker hood with pressing of
the sensor „S“.
Select the desired capacity level (1, 2 or 3)
Press the timer sensor „T“.
The capacity level can be changed during
the operation in the „TIMER“ mode.
The deactivation of timer can be made with
repeated pressing of sensor „T“.

EN 4
REMARK
At switching off of the cooker hood with
sensor „S“ also the timer function is switched
off.
CLEAN AND FRESH FUNCTION
METHOD
Switch on the cooker hood with pressing of
the sensor „S“.
Activate the CLEAN and FRESH function
with pressing of the sensor „C“.
Every hour the cooker hood will be
switched on for 5 minutes during this
activated function.
The cooker hood in this mode is working on
the capacity level no.1.
REMARK
The CLEAN and FRESH function will be
automatically switched off at switching of
cooker hood to „BOOSTER“ or to other
capacity level.
DEACTIVATION OF CLEAN AND
FRESH FUNCTION
With repeated pressing of sensor „C“.
SIGNAL LIGHT FOR THE POLLUTION
LEVEL OF THE FILTER
The signal light for the pollution level of the
filter will shine after 100 hour of operation of
the cooker hood. Provide the checking of
pollution level of the metal filter.
Press the sensor (symbol “F”) for at least 5
seconds after provided check and cleaning
of the filter, the counter of operation hours
will be set to zero with it.
AUTOMATIC SWITCHING OFF OF
THE COOKER HOOD
If no change in the setting or other selection is
made up to 5 minutes from switching on of the
cooker hood with the sensor „S“, then the
cooker hood switches automatically off.
SAFETY SWITCHING OFF OF THE
COOKER HOOD
It switches everything except the CLEAN
and FRESH function off.
If no change in the setting of the cooker
hood is made during the last 48 hours, a
safety switching off of the cooker hood is
realized.
MAINTENANCE AND CLEANING
At cleaning or maintenance switch the
appliance off from the power and this with
disconnecting from the socket or with
switching off of corresponding circuit
breaker.
The regular maintenance and cleaning
ensure the efficiency, reliability and longer
lifetime of cooker hood.
Pay special attention to grease filter and to
carbon filter.
For cleaning of cooker hood do not use
cleaning articles containing aggressive
substances mainly chlorine and
dissolvents.
GREASE METAL FILTER
The grease metal filter (F) catches the fat
particles.
The metal filter should be cleaned manually
or in dishwasher (at 65 C) with use of
appropriate detergents.
The filter can slightly change its color when
washed in dishwasher; nevertheless this
fact has no influence to its functionality.
Let the filter thoroughly dry after washing
and return it to cooker hood in dry state
only.
CASSETTE CARBON FILTER
The carbon filter (E) absorbs the kitchen
smell.
The carbon filter should be never
washed!
Provide the cleaning cycle always after
lighting on of symbol „F“ on the control
board of cooker hood.
INSTALLATION OF CASSETTE
CARBON FILTER
Disconnect the appliance from the power
net.
Take out the grease filter (F) and fasten the
cassette carbon filter (E) to its internal side
–see the picture.
NOTICE!
The caught fat in the filter has influence not
only to the effectiveness of cooker hood but at
neglected maintenance could cause also a

EN 5
fire! Therefore we recommend the
observation of instructions for cleaning and
changing of filters.
LIQUIDATION OF CARBON FILTERS
AFTER FINISHED LIFETIME
The used filters can be put to normal
household waste.
The liquidation should be provided in
concordance with the corresponding
national standards and regulations.
CLEANING
Clean regularly the internal and external
parts of cooker hood with soft cleaning
agents.
Never use abrasive cleaning means.
Clean the glass surfaces with special
means for glass, mirrors and windows.
METHOD OF USE AND LIQUIDATION
OF PACKAGING
Grooved cardboard, packaging paper
- sale to waste collecting company
- to collecting vessels for used paper
- other reuse
Polystyrene
- to corresponding collecting vessels
Packaging foil and PE backs
- to collecting vessels for plastic
LIQUIDATION OF APPLIANCE AFTER
FINISHING OF USE
This appliance is marked in accordance with
Directive 2012/19/EU on manipulation with
waste from electric and electronic equipment
–WEEE. This directive determines the unified
European (EU) frame for collection and
recycling of used equipment.
The appliance contains valuable materials
which should be reused after finishing of their
use. Please give your used appliance to
waste processing company.
CLAIMS
If there is any defect on the appliance within
the guarantee period, do not repair it self.
Apply a claim in the shop in which you bought
the appliance or at service representatives,
mentioned in the Guarantee conditions.
At applying of claim observe the text of
Guarantee sheet and GUARANTEE
CONDITIONS.
REMARK
The producer reserves the right for providing
of minor changes, resulting from innovations
or from technologic modifications of the
product