Governors America EEG6500 User manual
1Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
EEG6500
Enhanced Electronic Governor
1
2
INTRODUCTION
SPECIFICATIONS
PERFORMANCE
Isochronous Operation ± 0.25 %
Speed Range / Governor
100 Hz - 12 KHz
(200-6000 RPM
Droop Range
Speed Trim
INPUT / OUTPUT
Power Consumption continuous
1.0 - 60.0 V RMS
@77 °F (25 °
Load Share/
Reverse Power Protection Yes
60 V
-
Sharing
ENVIRONMENTAL
up to 95 %
PHYSICAL
Dimension
Weight
Mounting
RELIABILITY
Vibration
Shock 20 g Peak
Testing
COMPLIANCE / STANDARDS
Communications
2Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
3
in moist environments.
[mm]
in
Dimensions:
COM VSPD
EEGEnhanced Electronic Governor
6500
www.governors-america.com
- CAUTION -
ENGINE SPEED CONTROL COMPONENT
SEE PRODUCT PUBLICATION WHEN
INSTALLING OR SERVICING
N P
CAN
M
AUX
IDLE
L
DROOP
KJHG
BATT
FE
H J K L
V.SPD
IDLE
DROOP
A: Actuator
B: Actuator
C: Pickup
D: Pickup
E: Battery -
F: Battery +
G: Not Used
H: Common
J: Variable Speed
K: Droop
L: Idle Select
M: Auxiliary Input
N: CANbus (Low)
P: CANbus (High)
TERMINALS
L H
-+
PICKUP
DC
ACT
BA
u.s.a.
CBA
INSTALLATION
3Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
A DCB E F N P
Actuator
Battery
- +
Magnetic
Speed
Pickup
Fuse 15A Max
Ground to Case
(12V or 24V)
A NDCB E HGF LKJ M PA NDCB E HGF LKJ M P
CAN J1939
( Optional )
Accessory
Input
Droop
Idle
Variable Speed / Trim
Potentiometer 120 Ohms
( End of CAN bus)
Ground to
Case
Ground to
Case
5KΩ
COM
VSPD
4WIRING
TERMINAL DEFINITION GAUGE / mm2NOTES
#16 / 1.31
B #16 / 1.31
CMagnetic Pickup
#20 / 0.52
DMagnetic Pickup
#20 / 0.52
#16 / 1.31
F #16 / 1.31
or short circuit
H #16 / 1.31
J
Input #20 / 0.52
increases speed
K #16 / 1.31
L #16 / 1.31
M #20 / 0.52
N #20 / 0.52
P #20 / 0.52
RECOMMENDATIONS
1.
2.
5K RESISTIVE SPEED TRIM POT
0-2.5 V OR 4-20 MA* VARIABLE SPEED INPUT
*
IMPORTANT
4Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
5DISPLAY & CONTROLS
Locking/Unlocking the Display
-
-
Once the LOCK parameter on the main menu is en-
PARAMETER UNITS
PARAMETER VALUE
SECONDARY PARAMETERS
OVERCURRENT
QUIKSET MENU
FUEL LIMIT
unchanged.
OVER SPEED
LOCK
21 3
Tap any
Hold
COLUMN SELECT BUTTONS
Parameter
Parameter
Down
Increment a Parameter Value:
Rapidly Increment a Value:
HOLD and HOLD or
Lock the Display:
PARAMETER ADJUST
END USER INTERFACE
ACTUATOR DUTY CYCLE
100%= 11 Bars
90-99% = 10 bars
...
10-19% = 2 bars
1-95% = 1 bar
0% = 0 bars
PRIMARY PARAMETER VALUE
PRIMARY PARAMETER UNITS
one direction.
PRIMARY PARAMETER (UNITS)
SECONDARY PARAMETER
ENGINE SPEED
Bottom bar = set point - 10 RPM
SECONDARY PARAMETER
5Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
6FEATURES
SPECIAL MENU
PARAMETER
QUIKSET MENU
PARAMETERS
VSPD MODE SPEED V. SPEED
OFF Trim
ON
Speed
Minimum speed when potentiometer
TRIM or VARIABLE SPEED OPERATION
Trim Function
Variable Speed Function
-
RESISTIVE, VOLTAGE OR CURRENT INPUT TO TERMINAL J
COM
A DCB E HGF LKJ M
HJ
5KΩ
CCW
Terminal J Utilizes A
CCW Potentiometer
VSPD
Conversion Formulas:
Hertz
60sec
RPM = (Hertz
# Teeth
IDLE SPEED
AUXILIARY INPUT
6Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
7
#TEETH
CRANK
SPEED
ADJUSTABLE QUIKSET PARAMETERS
OVER SPEED * #TEETH CRANK *
Range: 400 - 6000 RPM
Range: 60 - 250
Range: 100 - 1000 RPM
SPEED RAMP V.SPEED * LOCKED
Range: 25 - 2000
Press and
START FUEL DROOP% FUEL RAMP
Range: 0 - 100%
Range: 0 - 25.0%
Range: 1 - 100% / Sec.
cranking
SPEED * IDLE * FUEL LIM
Range: 150 - 1500 RPM
Range: 0 - 100%
GAIN STABILITY DEADTIME
-
PRE-START SET-UP & qUICkSET PARAmETERS
7Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
8ADJUSTING FOR STABILITY
GAIN - RATED SPEED & IDLE SPEED
-
GAIN TYPE ADJUSTMENT PROCEDURE
1.
1.
2.
3.
on the Quikset Menu.
QUIKSET MENU
PARAMETER ADJUSTMENT PROCEDURE
1.
2.
3.
4.
B. 1.
2.
C. 1.
NOTE
9ADJUSTING FOR DROOP
EXAMPLE
1.
2.
3.
4.
5.
6.
7. DROOP to the desired percentage.
8.
9.
The NLCU entered must be than the FLCU
8Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
10 ADVANCED PARAmETERS mENU
ADVANCED MENU PARAMETERS (CONFIGURABLE)
Parameter Denition Range Default
Auxiliary Input
VSPD Variable Speed
LFG Light Force Governor
Lead Circuit - For Increased Governor
On
No Load Current 0.0 - 9.5 0.5
Full Load Current 0.5 - 10.0 4.0
ADVANCED MENU PARAMETERS (READ ONLY)
Parameter Denition
BID
FLTH
FLTL
Previous
Parameter
Parameter
Selecting Parameters:
Display Special
Menu Parameters:
Return to Quikset Menu:
Adjust Parameters:
1.
Quikset Menu.
2.
Increase
Parameter
Decrease
Parameter
9Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
LIGHT FORCE GOVERNOR
LEAD CIRCUIT
OEM SAVE SETTINGS
OEM SAVE
OEM RESTORE
OEM RESTORE
10 ADVANCED PARAmETERS mENU (CONTINUED)
10 Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
FACTORY RESTORE
FACTORY RESTORE
-
10 ADVANCED PARAmETERS mENU (CONTINUED)
11 FAULT CODES
ADVANCED MENU PARAMETERS (CONFIGURABLE)
CODE CAUSE EFFECT CUSTOMER ACTION
1 Check actuator wiring.
2
Check speed pickup.
3
203
settings.
206
setting. Check potentiometer wiring.
241
251 -
down.
307
IMPORTANT
12 J1939 CAN INFO
J1939 Address: 26
PGN DEFINITION NOTES
61444
11 Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
INSTABILITY
INSTABILITY SYMPTOM PROBABLE CAUSE
Fast Periodic
speed.
1.
2.
1.
2.
a. binding
Parameter set too high.
Non-Periodic
1.
13 SYSTEm TROUBLESHOOTING
SYSTEM INOPERATIVE
STEP WIRES NORMAL READING PROBABLE CAUSE
1
1.
2.
3.
Wiring error
2
1.
2.
3.
4.
Gap between speed sensor and gear teeth too great
to the speed sensor
Resistance between D and
D
3 1.0 - 2.0V DC
1.
2.
3.
4.
5.
Short/open in actuator wiring
SYMPTOM NORMAL READING PROBABLE CAUSE
1.
1.
2.
-
1.
2.
3.
1.0 to 2.0 V DC:
a. actuator binding
3. 1. Incorrect tooth count entered.
Over Speed shuts down
speed is reached
1. -
1.
2.
3.
4.
5.
6.
Over Speed shuts down
speed is reached
1.
-
1.
2.
UNSATISFACTORY PERFORMANCE
12 Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
www.governors-america.com
UNSATISFACTORY PERFORMANCE
SYMPTOM NORMAL READING PROBABLE CAUSE
1.
1.
Then: 1. Check wiring
2.
1.
2.
3.
4.
5.
actuator or harness.
desired governed speed
1.
1.
2.
13 SYSTEm TROUBLESHOOTING (CONTINUED)
13 Governors America Corp. © 2020 Copyright All Rights Reserved
EEG6500 Series Enhanced Electronic Governor 6-2020-A3 PIB5010
EEG6500 Technical Assistance Worksheet
Date:
Phone Number:
EEG6500 GOVERNOR SETTINGS
Parameter Factory Settings Customer Settings
Gain
50
Deadtime HI
Speed 1500RPM
900 RPM
100
100
Droop % 5.0
10
Speed Ramp 300 RPM/sec
V. Speed
Overspeed 2000 RPM
120
Crank 400 RPM
ADVANCED SETTINGS
Parameter Factory Settings Customer Settings
VSPD
LFG
0.5
4.0
0
FLTL ------
------
FLTL ------
ELECTRICAL CHECKS
ADVANCED MENU PARAMETERS (READ ONLY)
Parameter Factory Settings Software Revision
Number
------
Table of contents
Popular Industrial Monitor manuals by other brands
Cincoze
Cincoze CS-100/M1000 Series user manual
SBC
SBC PCD7.D5 RF Series user manual
Rompa
Rompa snoezelen Colour Catch Combo 24511 instruction manual
Industrial Automation and Enclosures Inc.
Industrial Automation and Enclosures Inc. RLCD170 user manual
Hope Industrial Systems
Hope Industrial Systems HIS-RL15- ***D Series user manual
Pepperl+Fuchs
Pepperl+Fuchs VisuNet EX2 GMPRM/PC 3700 Series Hardware manual
Honeywell
Honeywell W8600F installation instructions
Siemens
Siemens SIMATIC Industrial Flat Panel IFP1500 quick start guide
GE
GE QuickPanel+ IC755CxS06RDx user manual
Canvys
Canvys PD-BE32AU-OND user manual
Microgate
Microgate WITTI-TAB user manual
Eaton
Eaton Crouse-Hinds MTL GECMA WS Series instruction manual