Gower Camden Dove Grey Built Under Oven Unit User manual

600 Built Under Oven Unit Assembly
Components
Ref. No. Item Quantity Ref. No. Item Quantity Ref. No. Item Quantity Tools Required
1 2 Assembly Instructions 3Without Drawer 4With Drawer
Important Information - True Handleless Kitchens Installers: See Note Above TH
154085 10
154068 6
10
154004 2
151999
152401 4
152418 4
152402 2
5mm
Drill
Spirit Level
G-Clamp
(pair)
Medium Crosshead
Screwdriver Hammer
Tape Measure
Bradawl
Large Flathead
Screwdriver
150101 4
3.5x12mm
150202 14
4x12mm
154082 10
4x15mm
150201 22
150308 2
150309 2
154047 2
A
A
B
B
C
D
D
4x25mm
150124 8 154014 2
154015 2
Note: Supports D not used if fitting drawer.
1 2 1 2
1 2
1 2 1 2
A
1212
12
1212
A
2
10
154004
2
1
1
154082 10
3
8
150124
3
3 3 3 3
A
D
619mm
50mm
Note: Left hand panel shown only, mirror
for right hand panel.
4
A
619mm 619mm
70mm 400mm 4
Drawer runner
684mm
4
4
150202 154068
4
4
Note: Left hand panel shown only, mirror
for right hand panel.
3.5 x 16mm x2
x4
Fit as third screw
Front 1 x 'L'; 1 x 'R'
Drawer Runner
Caution: Some pieces of hardware could be hazardous to small children. Keep all these items out of reach and do not leave children unattended in the assembly area.
Please read these instructions carefully before proceeding. Refer to the Guide to Receiving and Installing your Kitchen booklet for further information.
Note: Due to variation in wall conditions no screws are supplied for fixing the units to the wall. If in doubt consult an expert. Assemble the unit on a clean solid work surface.
In the interest of continuing improvements we reserve the right to amend or adjust the specifications without prior notice. Errors and omissions excepted.
These units may be fitted with a drawer system. The drawers are supplied separately. These instructions show the runner positions for the drawer system.
Follow the instructions supplied with the drawers for drawerbox assembly.
Every effort has been made to ensure that this product leaves the factory in perfect condition. In the unlikely event that an item is damaged or incorrect, please contact the customer services department.
Note - Fitting Handles: (1) Decide where you are going to position each handle to maintain symmetry around your kitchen. (2) Measure the handle centres and mark off each door/drawer position. (3) Drill through the door/drawer
using a fine drill (<2.5mm), then drill back from the rear face using a 4.5mm drill. (4) Attach with the fixings provided with your handle.
FM 665131
Note: If fitting a “True Handleless” kitchen, some
components will differ to those shown in this instruction
and will also be packaged separately. Please refer to your
True Handleless guide to Receiving for further details on
the different components and difference in installation.
TH
TH Modification required at this stage, see True
Handleless guide for further details.
Note: For ease of fitting, Step 17 can
be completed at this point.

56 7
8 9 10 14 Installation Instructions
15 16 Without Drawer 17 18 Without Drawer 19 20 With Drawer
8
TOP
5
10
154085
5
C
5
B
5
5
5
5
B
5
5
5
5
5
6
7
A
A
B
6
6
B
CD
6
6
6
6
6
6
6
6
140mm
4
152418
4
152401 150201
16
8
8
8
9
9
8
9
9
9
8
8
12
2
150308 150309
2
82mm
11
5mm
12
10
10
11
11
12
12
13
13
13
13
==
14
14
45mm
10
4
150202 154047
2
10
11
2
150202 154068
2
14
14
150101
4
152402
2
13
4 (Only if
Drawer is
being fitted)
150202
13
25mm
59mm
25mm
59mm
16
16
15
15
TOP
15
25mm
59mm
2
154014 150201
2
15
16
2
151999
2
154015 150201
4
17
40mm
32mm
37mm
17
17
17
18
18
20
2
151199
TOP
64mm
31.5mm
32mm
19
19
19
20
20
Ref. 170805 (05)
17
17
16
20
Start Locked
Do Not Over Tighten
Note: Do not over tighten screws
or use a power screwdriver.
TH Modification required at this stage, see True
Handleless guide for further details.
TH Modification required at this stage, see True
Handleless guide for further details.
Note: For ease of fitting, Step 17 can
be completed at same time as Step 3.