GP CR42 User manual

CR42 Flashlight
Instruction Manual

Read the instruction manual thoroughly before use.
Keep the manual for future reference.
Operating instructions
GBGB
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
Contact your local government for information regarding the collection systems available. If electrical
appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater
and get into the food chain, damaging your health and well-being.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Charging / changing battery:
1. Unscrew the tail cap (A)
2. Ensure Li-ion 18650 battery inserted correctly in battery holder
3. Plug the Micro USB end into the ashlight. Plug the USB end into a power source
such as a computer, power bank charger, USB wall socket adapter or USB car
charger
4. LED indicator light:
Green LED: Charging completed
Red LED: Charging in progress
5. Disconnect the USB cable when fully charged and screw tail cap (A) to ashlight
6. In the event you want to change the battery unscrew the charging base (B) and
remove discharged battery
7. Replace with charged battery taking care to install according to polarity markings +/-
and replace charging base (B)
8. Screw on tail cap securely
Operation:
• Full press switch on tail cap for On/Off
• Full press switch -> High -> Half press switch -> Medium -> Half press switch -> Low
-> Half press switch -> Eco -> Half press switch -> SOS (Half press to cycle repeats)
• Alternatively full press On and Off -> cycle repeats
Safety Instructions and Warnings
Use the device in a temperature range between -20 and 60°C and avoid exposure to direct
heat and constant sunlight.
This appliance is not intended for use by young children or inrm persons unless they have
been adequately supervised by a responsible person to ensure that they can use the
appliance safety. Young children should be supervised to ensure that they do not play with
the appliance.
Do not cover the headlamp or place face down on a surface when the light is switched on
Use 1 x Li-ion 18650 battery with integrated overcharge and over-discharge Protection
Circuit Module (PCM). Failure to use high quality batteries with PCM may result in damage
to the ashlight and battery.
Replacing battery
When changing batteries rst switch off ashlight before removing tail cap (A) and install
new batteries in the appropriate battery holder. Screw the tail cap when batteries have
been correctly tted according to prescribed polarity markings on the battery holder (+)
and (-). Care should be taken that the batteries are installed in accordance with the battery
polarity.
B A