
Choose a location where the vehicle is outdoors and NOT
underground. eg. carpark or garage. In a single motion, push the
RoadScout device firmly all the way into the OBD port. Wait until the
GPS light flashes green.
2. Install directly into the OBD-II port
GPS LED SOLID - No GPS
GPS LED FLASHING - GPS FIX
Ensure the device does not protrude out or interfere
with the driver entering, exiting or operating the
vehicle. If the device does interfere please call our
help desk for alternative installation options.
IMPORTANT SAFETY NOTE
3. Start the vehicle
When the GPS light is flashing start the
vehicle. Once the vehicle is running scan
the Activation QR Code on the box or go
to using your mobile setup.gpsi.com.au
internet browser.
It is law that any vehicle being monitored
must have a notice that is clearly in view
of the driver. Place the sticker high on
the inside corner of the windscreen.
Enter the IMEI number found on the side
of the box or on the device. If you see 4
orange ticks you have successfully installed
the RoadScout device. Complete the install
be adding the odometer reading and
pressing Submit.
Apply the GPS Notice Sticker
4. Device Activation
Well done!
You have successfully completed the install.
RoadScout
Setup
GSM
GPS
OBD
Enter the Odometer