GPS CI-2 Instruction manual

Installation, Operation & Maintenance Manual
™
NOTICE: This product is to be used only as directed. Read entire manual before use. Do not use unless properly installed.

For technical product queries, please reach out to [email protected]
Thank you for purchasing a CI-2™ air ionization system from GPS Air.
What’s Included
Before you start, confirm the contents of your shipment. Each CI-2™ will consist of the following:
1. CI-2 Air Ionization System
2. CI-2 Mounting Bracket
3. Installation Fasteners (2)
Not Included
1. Electrical wiring, junction box, or receptacle to provide power to the CI-2
(2)
(1)(1)
Product Registration
By registering your order, the standard limited warranty on eligible products from
your purchase is automatically extended to 3 years, at no additional cost.
Register your products at www.gpsair.com/product-registration or scan the QR
code.
Location
NOTE: Device should be installed after any filtration in system.
WARNING: Make sure power is disconnected to the HVAC equipment before installation.
NOTE: Use temperature - Maximum ambient temperature in which unit shall be used: 140°F/60°C.
AVERTISSEMENT: Assurez-vous que l'alimentation de l'équipement HVAC est débranchée avant l'installation.
REMARQUE: Température d'utilisation - Température ambiante maximale à laquelle l'unité doit être utilisée: 140°F/60°C.
The CI-2 is capable of being installed in a wide range of applications. Actual location and suitability will vary
based on equipment manufacturer. Some recommended installations are below.

Installation
1. The integral magnet (see Figure 1) can be used in low vibration locations on ferrous
surfaces.
2. The mounting bracket should be used with appropriate fasteners in high vibration and
on non-ferrous surfaces (see Figure 2)
3. Airflow should be aligned with the indicator on the CI-2 (see Figure 3)
Installation Methods
Improper Installation Methods
Figure 3Figure 1
Magnet located here
Figure 2
Magnet Installation
improper airflow direction airflow not interacting with emitters
blocked airflow wet conditions
Bracket Installation
Airflow
Airflow

Air Handler
1. Optimum installation location is on the fan inlet.
Ceiling Cassette
1. Optimum installation location is on the fan inlet shroud.
2. Ensure installation of device does not hinder or interfere with any covers on ceiling cassette.